Jenn-Air JVD0303GS Use and Care - Page 4
Vent Use
View all Jenn-Air JVD0303GS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
VENT USE To Turn On Vent: 1. Push down on the left side of the vent door and hold door against stop until the Vent Control light is illuminated. A magnet will then keep the vent door open. NOTE: The vent will not operate if the vent door is closed. 2. Tap the bar ( ) above the "1" keypad for low speed. Tap the bar ( ) above the "2" keypad for high speed. NOTE: The vent has a Timer On mode. Tap the bar ( ) above the "15 MIN" keypad. The vent will only run on low speed and will automatically turn off after 15 minutes while in the Timer A. Vent door B. Vent filter C. Filter handle D. Cooktop E. Vent controls The vent removes cooking vapors, odors, and smoke from the cooktop area. The vent consists of a vent filter, vent ducting, and a vent fan. ■■ For best results, the vent should be turned ON before cooking is started. ■■ A higher heat setting than normal may be needed when the vent is operating. ■■ The handle of the vent filter should be on the left-hand side of the filter opening when facing the front of the vent. See the previous illustration. IMPORTANT: Only operate the vent with the vent filter properly installed. Clean the filter regularly. Non-vented (recirculation) use requires the installation of the Recirculation Kit Accessory. To Use: To Turn Off Vent: 1. This delay prevents accidentally turning the unit off. LED Illumination A B 1 2 15 MIN OFF A. LED light B. LED light switch 4