Jenn-Air JWD3027EX Installation Guide - Page 7
Custom Drawer Front Installation Instructions, For Warming Drawers
View all Jenn-Air JWD3027EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
7. Use the two #8-18 x1/2" screws provided to secure the warming drawer frame to the cabinet. A A. Two #8-18 x 1/2" screws Complete Installation 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your tools. 3. Dispose of/recycle all packaging materials. 4. For warming drawer use and cleaning, read the Use and Care Guide. 5. Push in and turn the control knob to HI, and the light should illuminate. If warming drawer(s) does not operate, check the following: ■■ Household fuse is intact and tight, or circuit breaker has not tripped. ■■ Warming drawer is plugged in, and electrical supply is connected. If you need Assistance or Service: Please reference the "Warranty" section of the Use and Care Guide. CUSTOM DRAWER FRONT INSTALLATION INSTRUCTIONS FOR WARMING DRAWERS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools Needed ■■ Phillips screwdriver ■■ Drill and appropriate bits Parts Supplied ■■ #8-18 x 1/2" screws (6) ■■ Indicator light lens Parts Needed ■■ Custom drawer front ■■ Custom handle (optional) ■■ Adhesive recommended for plastic to wood Install Custom Drawer Front Panel The warming drawer has an interface that will allow a modest range of panel sizes. The actual panel size should be selected by the customer and the contractor to suit the desired effect. It is recommended that a qualified carpenter make and install the custom drawer front and handle(s) to match surrounding cabinetry. 1. Install warming drawer unit as instructed by the Installation Instructions provided with the warming drawer. 2. Create the custom drawer front. Below are the minimum and maximum dimensions for the custom drawer front. The size of the custom drawer front for the warming drawer will vary according to the specific installation. The depth of the panel will vary in order to have the custom warming drawer flush with the surrounding cabinets. A 7.9 mm) dia. hole for indicator light lens (provided B in this kit). Locate lens directly in front of indicator light. Model A - MAX B - MAX A - MIN 24" (60.9 cm) 233/4" 105/16" 23" Warming (60.3 cm) (26.2 cm) (58.4 cm) Drawer 27" (68.6 cm) 263/4" 105/16" 26" Warming (67.9 cm) (26.2 cm) (66.1 cm) Drawer 30" (76.2 cm) 293/4" 105/16" 29" Warming (75.6 cm) (26.2 cm) (73.7 cm) Drawer B - MIN 91/16" (23.0 cm) 91/16" (23.0 cm) 91/16" (23.0 cm) 7