Jensen JENMP6512I Operation Manual - Page 21

MP6512i

17

SATELLITE RADIO OPERATION

Listeners can subscribe to XM

®

Radio on the Web by visiting

www.xmradio.com, or by calling (800) 967-2346. Customers should

have their Radio ID ready (see “Displaying the Identification (ID)

Code”). Customers can receive a limited number of free-to-air

channels without activation.

Listeners can subscribe to Sirius

®

Radio on the Web by visiting

www.sirius.com, or by calling (888) 539-SIRIUS. Customers should

have their Sirius ID ready (Sirius ID is located on the Satellite Radio

Tuner, sold separately). Customers can listen to music samples by

tuning to channel 184.

Accessing Satellite Radio Mode

To switch to Satellite Radio mode, press

SRC

(7) until “- - SAT - -” appears

on the display. This will not be displayed unless the unit is connected to an

optional XM or Sirius receiver.

Displaying the Identification (ID) Code

Before you listen to Satellite Radio, you must subscribe to the service using

your radio’s identification number. To display the radio ID, press the

TUNE/

TRACK |<<

button (19) to access channel 000. The screen displays

“RADIO ID” followed by the ID number.

Selecting a Station

Press the

TUNE/TRACK >>|

or

|<<

button (19) to change to another

station.

Press and hold

the

TUNE/TRACK >>|

or

|<<

button for more than

one second to fast forward or fast reverse through the stations.

Preset Stations

Press the

BAND

button (3) to change between three SAT Radio bands.

Each band stores up to six preset stations. You can store and recall a total

of 18 preset stations.

Store a Station

1.

Select a band (if needed), then select a station.

2.

Hold a preset button (14) for three seconds. The preset number

appears in the display.

Recall a Station

1.

Select a band (if needed).

2.

Press a preset button (14) to select the corresponding stored station.

Direct Tuning Mode

To enter a station directly, perform the following steps.

1.

Press the

AS

button (15) once. “Direct” appears on the screen.

2.

Press the

MENU

button (22) to display CH 001.

3.

Turn the rotary encoder to select the third digit of the desired channel

(0-9).

4.

Press

MENU

(22) to enter the number and move to the second position.

5.

Turn the rotary encoder again to select the second digit of the desired

channel (0 - 9).

6.

Press

MENU

to enter the second number and move to the first position.

7.

Turn the rotary encoder again to select the first digit of the channel you

want to tune to (0 - 2).

8.

Press

MENU

to enter the final number and access the channel.

NOTE: If the channel is unauthorized or invalid, “CH Unavail” appears

on the LCD and the unit returns to the input interface after 2 seconds.

MP6512i

/

SAT

READY

Jensen JENMP6512I Operation Manual - Page 21

Satellite Radio Operation

Page 21 highlights