Jensen JPA460 Quick Start Guide - Page 1
Jensen JPA460 - Amplifier Manual
UPC - 043258301291
View all Jensen JPA460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
JPA460 4-Channel Amp Quick Start Guide RCA Cables Remote / Power Antenna Turn-on Wire AMP +12V REM GND (LF+) BRIDGED (LF-) (RF-) (RF+) BRIDGED (LR+) (LR-) (RR-) (RR+) CAR STEREO / SOURCE UNIT LEFT FRONT RIGHT FRONT SPEAKER SPEAKER LEFT REAR RIGHT REAR SPEAKER SPEAKER Minimum Wire Size: +12V - 6 AWG Ground - 6 AWG CHASSIS GROUND () (+) - Need help? For technical assistance, call the Jensen customer support line at 1-800- 323-4815. BATTERY Fuse Block or Fuse Holder 1. Disconnect the negative (-) battery terminal. NOTE: Check your vehicle's owners manual before disconnecting the battery. Disconnecting the battery in some vehicles may require an anti-theft code when reconnecting for stereo operation. Some vehicles may run rough after reconnecting the battery and require service to have the on-board computer reset. Check with your local dealer if you are uncertain. 2. Run suitable AWG wire to where the amplifier will be mounted (run 1 foot extra than you think you will need). Use rubber grommets where wires will pass through the firewall or other areas of the vehicle. Make certain a fuse holder is placed within 18 inches of the vehicle battery - this is mandatory. Do not place a fuse in the fuse holder at the battery at this time. 3. Mount the amplifier on a flat surface. Since a flat surface in a modern vehicle is often difficult to find, an alternative is to cut a piece of 1/2 inch wood slightly larger than the amplifier mounting area (covered with automotive type carpeting). Mount the piece of wood, and then mount the amplifier to the carpeted wooden mount. 4. Ground the amplifier using the same AWG wire size used for the power cable. Make sure the ground location is a clean, unpainted metal surface. 5. Run the RCA and Remote turn-on lead to the amplifier from the head unit. 6. Run speaker wires (16 AWG or larger) from your speakers to the amplifier. 7. Place a suitable size fuse in the fuse holder at the battery. 8. Ensure that the crossover is set to "OFF" and that the input level control is set to "MIN". 9. Turn on the head unit and make appropriate amplifier adjustments.