Jensen MP5720 Owners Manual - Page 3

MP5720 Preparation (continued) Install Half-Sleeve 1. Install adapter if necessary (optional). 2. Install half-sleeve into adapter or dashboard. 3. Push tabs out to secure half-sleeve in the radio opening. 4. Install support strap to make unit more stable. Wiring Wiring with a Wiring Adapter (Purchased Separately) Connect Wires You can make all these connections without even being in the car. 1. Splice or crimp wires. 2. Attach wiring adapter to car wiring harness. Wiring Diagram / Color Codes 1. Auxilliary input 2. Antenna 3. Power Antenna (dark blue wire) - Connect to power antenna or amplifier. If not used, tape bare end of wire. 4. Ground (black wire) - Connect to ground terminal or clean, unpainted part of chassis. 5. Memory/Battery (yellow wire) - Connect to battery or 12 volt power source that is always alive. The radio will not work if this wire is not connected. 6. Accessory/Ignition (red wire) - Connect to existing radio wire or radio fuse. 7. Left front speaker 8. Right front speaker 9. Left rear speaker 10. Right rear speaker 11. Rear RCA preamp out Fuses When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The MP5720 uses one 15 amp fuse located below the wiring connector: 15 amp fast blow ATO. Reconnect Battery When wiring is complete, reconnect the battery negative terminal. 3 Install Half-Sleeve Instalación de la Camisa Installation du Demi-manchon 4 3 1 2 Connect Wires Conecte los Cables Raccordement des Fils Jensen Connector 1 2 1 10A 2 Wiring Cableado Câblage 3 Rear 11 Posterior Arrière Gray Gris / Gris 4 + 5 6 White/Black (-) Blanco/Negro (-) Blanc/Noir (-) 7 White / Blanco / Blanc (+) Green/Black (-) Verde/Negro (-) Vert/Noir (-) 9 Green / Verde / Vert (+) Gray/Black (-) Gris / Negro (-) Gris / Noir (-) 8 Gray / Gris / Gris (+) Violet/Black (-) Violeta/Negro (-) Violet/Noir (-) 10 Violet / Violeta / Violet (+)