Jensen UMP8015 Owners Manual - Page 15

UMP8015 CD CHANGER CONTROLS Built into the UMP8015 are controls to operate an optional CD changer. Please check with your Phase Linear car stereo specialist or call 1-800-323-4815 for recommendations of the models that will work with this radio. Adjustment of the audio functions (volume, tone, balance, and fader) and CD functions (Pause/Play, SCN, SHF, RPT and TRACK selection) for the CD changer operate in the same manner as they do for radio play. See the Operation and CD Player Operation sections for information about these topics. already in the changer, play resumes from the track on the disc previously in play. 17 , 18 Disc Select (CD-/CD+) The CD-/CD+ buttons (17 and 18) are used to select the desired disc for play. To advance to a higher number disc, press the CD+ button (18). To move to a lower number disc, press the CDbutton (17). The number of the disc in play is shown on the display panel. The following controls will operate the CD changer when it is installed and connected to this radio. Refer to the owner's manual included with the CD changer for instructions on the installation and correct loading and use of the CD magazine. AM/FM/CD/MP3/WMA/CASSETTE RECEIVER 7 ULTRASERIES UMP8015 7 3 in 1 CD/MP3/WMA CASSETTE RECEIVER 7 CD Changer Mode Selector 6 (MODE) Press the MODE button (7) to select operation of the CD changer, as shown by "CDC" on the display panel. Disc play begin and the disc and track number are shown on the display panel. If a new magazine has been loaded into the changer, play begins from the first track of the first disc in the magazine. If a magazine was 8 9 LOUD/ENTER 1 PAU 2 SCN 3 RPT 4 SHF 5 CD- 0 SCAN WMA / 6 CD+ MUTE AMS D-AUD 13 14 15 16 17 18 15