Jensen VM9213 Installation Guide - Page 2
Optional Equipment, Disconnecting the Battery, Pre-installation - bluetooth how
UPC - 043258304391
View all Jensen VM9213 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Optional Equipment NAV102: Before accessing any navigation features, you must purchase and install the navigation module (NAV102). All installation and operating instructions will be included with the navigation module. BTM10: Before you can connect to a Bluetooth enabled device, you must purchase and install the Jensen BTM10. Rear Camera: Before accessing any camera features, you must purchase and install a rear video camera. Disconnecting the Battery To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. NOTE: If the VM9213 is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit. Pre-installation 1 Remove the four screws that attach the mounting sleeve to the radio and remove the sleeve. 2 Install the mounting sleeve. a. Install mounting sleeve into the dashboard or optional adapter. Do not force the sleeve into the opening or cause it to bend or bow. b. Locate the series of bend-tabs along the top, bottom and sides of the mounting sleeve. With the 2c sleeve fully inserted into the dashboard opening, 2b bend as many of the tabs outward as necessary so that the sleeve is firmly secured to the dashboard. c. Install support strap to make the unit more stable. 3 Place the radio in front of the dashboard opening so the wiring can be brought through the mounting sleeve. CAUTION! Be careful not to damage the car wiring. 2 2a TAB TAB DASHBOARD DASHBOARD