Karcher HD 9/100 De Skid Operating instructions - Page 13
CAUTION, ATTENTION, Water connection, WARNING, High-pressure connection, DANGER
View all Karcher HD 9/100 De Skid manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
instructions. Unsuitable electrical extension cables can be dangerous. Only use approved and appropriately marked electrical extension cables with a sufficient cable cross section for outdoors. Only replace couplings on the power supply or extension cable using those with the same water density and the same mechanical strength. ṇ CAUTION In case of longer breaks in operation and after use, switch off the device at the main switch / device switch and pull the mains plug. ATTENTION Switch-on procedures will generate short-term voltage drops. Unfavourable mains conditions may cause other devices to be impaired. In case of a network impedance of less than 0.15 ohms, no malfunctions are to be expected. Water connection ṇ WARNING The screw connections of all connection hoses must be leak-tight. Do not exceed the maximum permissible water supply temperature. Route the hose lines in a safe manner. ATTENTION Use only hose lines rated for the operating pressure, mechanical loads and chemical loads present. Do not bend the hose lines beyond the minimum permissible bending radius. Replace the hose lines at appropriate intervals, even when no defects are visible. Hose lines have a limited service life. Observe the regulations at your water distribution company. High-pressure connection ƽ DANGER Use hose sleeves, protective covers or shields to eliminate hazards presented by the hose lines. ṇ WARNING The device must not be started up if the highpressure hose is damaged. Replace a damaged high-pressure hose at once. Only those hoses and connections recommended by the manufacturer may be used. For order no. see operating instructions. Do not subject the hose lines to mechanical, chemical or thermal loads. The screw connections of all highpressure hoses must be leaktight. Tighten the screw connections to a maximum tightening torque of 20 Nm. Use a hose catching fixture. Use only high-pressure hoses and accessories having a rated operating pressure of at least the same as the device. Check the highpressure hoses daily. Do not use kinked high-pressure hoses. Do not use high-pressure hoses having a visible outer wire mesh. Do not use high-pres- English 13