Kenmore 1320 Use and Care Guide - Page 9

Dishwasher Efficiency Tips

Page 9 highlights

FilterRemovalInstructions 1. Turn the Upper Filter Assembly 1¼turn counterclockwise and lift out. tab 2. Grasp the Lower Filter in the circular opening, lift slightly, and pull forward to remove. 3. Clean the filters as shown below. Cleaning Instructions IMPORTANT: Do not use wire brush, scouring pad, etc., as they may damage the filters. Rinse filter under running water until most soils are removed. If you have hard-to-remove soils or calcium deposits from hard water, a soft brush may be required. To remove Upper Filter Assembly J Filter Reinstallation Instructions 1. Noting the previous illustrations, place the Lower Filter under the Locating Tabs in the bottom of the dishwasher so the round opening for the Upper Filter Assembly lines up with the round opening in the bottom of the tub. ,4 3. Slowly rotate the filter clockwise until it drops into place. Continue to rotate until the filter is locked into place. If the filter is not fully seated (still turns freely), continue to 2. ItnusrnertthtehefiltUerppcelor ckFwiltieser Asusnetiml bitlydroinptso athned cloircckuslarinotopepnlaincge. in the Lower Filter. NOTE: The Upper Filter Assembly arrow does not have to align with the arrow in the Lower Filter as long as the filter is locked. O,__ S_ _ ,\ '_ ) To replace Upper Filter Assembly IMPORTANT: To avoid damage to dishwasher, do not operate your dishwasher without the ULTRA WASH ®HEfilters properly installed. Be sure the Lower Filter is securely in place and the Upper Filter Assembly is locked into place. If the Upper Filter Assembly turns freely, it is not locked into place. DISHWASHER EFFICIENCY TIPS Hot water dissolves and activates the dishwasher detergent. Hot water also dissolves grease on dishes and helps glasses dry spot-free. For best dishwashing results, water should be 120°F (49°C) as it enters the dishwasher. Loads may not wash as well if the water temperature is too low. Additional efficiency tips • To save water, energy and time, only scrape dishes. Do not rinse dishes before putting them into the dishwasher. • Use a delay feature to run your dishwasher during off-peak hours. Local utility providers recommend avoiding heavy usage of energy at certain times of day. • During the summer, run your dishwasher at night. This reduces daytime heat buildup in the kitchen. • Use a rinse aid to improve drying. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72

FilterRemovalInstructions
1.
Turn the Upper Filter Assembly
1¼turn counterclockwise
and lift out.
2.
Grasp the Lower
Filter in the circular opening,
lift slightly, and pull forward
to
remove.
3.
Clean the filters as shown below.
Cleaning
Instructions
IMPORTANT:
Do not use wire brush, scouring
pad, etc., as they may damage the filters.
Rinse filter under running water until most soils are removed.
If you have hard-to-remove
soils or calcium
deposits
from
hard water, a soft brush may be required.
tab
To remove Upper Filter Assembly
J
Filter Reinstallation
Instructions
1.
Noting the previous illustrations,
place the Lower Filter under the Locating
Tabs in
the bottom
of the dishwasher
so the round opening
for the Upper Filter Assembly
lines up with the round opening
in the bottom of the tub.
,4
2.
Insert the Upper
Filter Assembly
into the circular opening
in the Lower Filter.
_
3.
Slowly rotate the filter clockwise
until it drops into place. Continue to rotate until the
,_
O_
filter is locked into place. If the filter is not fully seated (still turns freely), continue to
S_
turn the filter clockwise
until it drops and locks
into place.
,\
NOTE:
The Upper
Filter Assembly
arrow does not have to align with the arrow in
'_
the Lower
Filter as long as the filter is locked.
)
To replace Upper Filter Assembly
IMPORTANT:
To avoid damage to dishwasher,
do not operate your dishwasher
without
the ULTRA WASH ®HEfilters properly
installed.
Be sure the Lower Filter is securely
in place and the Upper Filter Assembly
is locked into place. If the Upper Filter
Assembly
turns freely, it is not locked
into place.
DISHWASHER EFFICIENCY TIPS
Hot water dissolves
and activates the dishwasher
detergent.
Hot water also dissolves
grease on dishes and helps glasses
dry spot-free.
For best dishwashing
results, water should be 120°F (49°C) as it enters the dishwasher.
Loads may not
wash as well if the water temperature
is too low.
Additional
efficiency
tips
To save water, energy and time, only scrape dishes. Do not rinse dishes
before putting them into the dishwasher.
Use a delay feature to run your dishwasher
during off-peak
hours. Local utility providers
recommend
avoiding heavy
usage of energy at certain times of day.
During the summer, run your dishwasher
at night. This reduces daytime
heat buildup
in the kitchen.
Use a rinse aid to improve drying.
9