Kenmore 1658 Use and Care Guide - Page 5

This Owner's Guide provides specific operating instructions for your model. Use the freezer only as instructed in this Owner's Guide. Before starting the freezer, follow these important first steps. iNSTALLATiON • Choose a place that is neara grounded electrical outlet. Do Not use an extension cord or an adapter plug. • For the most efficient operation, the freezer should be located where surrounding temperatures will not exceed t t0°F (43°C). Temperatures of 32°F (0°C) and below will NOT affect freezer operation. Additional compressor heaters are not recommended. • Allow space around the unit for good air circulation. Leave a 3 inch (75 mm) space on all sides of the freezer for adequate circulation. Lower Plastic Leveling Feet Crating Screw Discard Th_n_ng And (2) Wood Bases Screws Unpacking and Leveling - Upright Models 3" (75ram) To Level Chest Models: If needed, add metal or wood shims between foot pads and floor. (25ram) installation installation NOTE: The exterior walls of the freezer may become quite warm as the compressor works to transfer heat from the inside. Temperatures as much as 30 ° F warmer than room temperature can be expected. For this reason it is particularly important in hotter climates to allow enough space for air circulation around your freezer. LEVELING The freezer must have all bottom corners resting firmly on a solid floor. The floor must be strong enough to support a fully loaded freezer. NOTE: It is VERY IMPORTANT for your freezer to be level in order to function properly. If the freezer is not leveled during installation, the door may be misaligned and not close or seal properly, causing cooling, frost, or moisture problems. To Level Upright Models: After discarding crating screws and wood base, use a carpenter's level to level the freezer from front-to-back. Adjust the plastic leveling feet in front, 1/2bubble higher, so that the door closes easily when left halfway open. CLEANING Wash any removable parts, the freezer interior, and exterior with mild detergent and warm water. Wipe dry. Do not use harsh cleaners on these surfaces. Do not use razor blades or other sharp instruments, which can scratch the appliance surface when removing adhesive labels. Any glue left from the tape can be removed with a mixture of warm water and mild detergent, or touch the residue with the sticky side of tape already removed. Do not remove the serial plate. _To allow door to close and seal properly, DO NOT let food packages extend past the front of shelves. Shelf Front