Kenmore 2804 Owners Guide - Page 5
already removed, DO NOT REMOVETHE SERIAL PLATE. - model #
View all Kenmore 2804 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
This Owner's Guide provides specific operating instructions for your model.. Use the freezer only as instructed in this Owner's Guide Before starting the freezer, follow these important first steps, INSTALLATION • Choose a place that is near a grounded electrical outlet Do Not use an extension cord or an adapter plug • For the most efficient operation, the freezer should be located where surrounding temperatures will not exceed 110°F (43°C). Temperatures of 32°F (0°C) and below will NOT affect freezer operation. Additional compressor heaters are not recommended • Allow space around the unit for good air circulation Leave a 3 inch (75 mm) space on al] sides of the freezer for adequate circulation. 3" (75 ram) To Level Chest Models: /f needed, add metal or wood shims between foot pads and floor 3_(75mm) Installation NOTE: The exterior walls of the freezer may become quite warm as the compressor works to transfer heat from the inside. Temperatures as much as 30 ° F warmer than room temperature can be expected. For this reason it is particularly important in hotter climates to allow enough space for air circulation around your freezer LEVELING The freezer must have alI bottom corners resting firmly on a solid floor The floor must be strong enougil to support a fully loaded freezer NOTE: It is VERY IMPORTANT for your freezer to be level in order to function properly. If the freezer is not leveled during installation, the door' may be misaligned and not close or seal properly, causing cooling, frost, or moisture problems To Level Upright Models: After discarding crating screws and wood base, use a carpenter's level to level the freezer from front-to-back Adjust the plastic leveling feet in front, !/2 bubble higher, so that the door closes easily when left halfway open CLEANING Wash any removable parts, the freezer interior, and exterior with mild detergent and warm water Wipe dry DO NOT USE HARSH CLEANERS ON THESE SURFACES, Do not use razor blades or other sharp instruments, which can scratch the appfiance surface when removing adhesive labels Any glue left from the tape can be removed with a mixture of warm water and mild detergent, or touch the residue with the sticky side of tape already removed, DO NOT REMOVETHE SERIAL PLATE. _To allow door to close and seal properly, DO NOT let food packages extend past the front of shelves Shelf Front