Kenmore 28614 Owners Manual - Page 16

MOTOR SAFETY FILTER CHANGING ] WARNING Electrical Shock Hazard Turn off and unplug vacuum cleaner from electrical outlet, Do not operate the vacuum cleaner without the motor safety filter, Be sure the filter is dry and properly installed to prevent motor failure and/or electrical shock, MOTOR SAFETY FILTER ELECTROSTATIC This filter must be replaced when dirty.. It should be replaced regularly depending on use conditions. The filter CANNOT be washed as it will lose its dust trapping ability. NOTE: See PARTS AND FEATURES for Motor Safety Filter number. 1. Remove the bag as outlined in the BAG CHANGING section,, 2, Lift the rubber retainer and pull out motor safety filter as shown., 3. Replace the filter, white side out, facing the dust bag, by sliding it back into place under the ribs in the bag cavity, Tuck filter in so that it fits completely under the rubber retainer. 4. Replace the bag as outlined in the BAG CHANGING section° EXHAUST FILTER CHANGING , , ,, , , WARNING Fire and!or Electrical Shock Hazard Do not operate with a clogged exhaust filter or without the exhaust filter or exhaust filter cover installed° Filter EXHAUST FILTER HEPA The exhaust filter cartridge must be replaced when dirty. Replace the filter when the entire surface area is covered evenly° The filter CANNOT be washed as it will lose its dust trapping ability. NOTE: See PARTS AND FEATURES for Exhaust Flter number, 1. Pull out and up on the exhaust filter cover to remove from the canister and lay aside. 3. Replace the exhaust filter cartridge° Place the new filter into the canister with the foam seal facing towards the canister, Tabs 16 I 2. Pull the exhaust filter up and out from the rear of the canister° Filter 4, Replace the exhaust filter cover by placing the two tabs on the filter cover into the slots on the canister and rotate into place until it snaps closed,,