Kenmore 4061 Use and Care Guide - Page 21
You Call - review
View all Kenmore 4061 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Before You Call Solutions to Common Problems Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance. OCCURRENCE Oven Control Beeps and Displays any F code error (example F11). POSSIBLE CAUSE/SOLUTION Electronic control has detected a fault condition. Press STOP/CLEAR to clear the display and stop beeping. Reprogram the oven. If a fault reoccurs, record the fault number. Press STOP/CLEAR and call Sears or another qualified servicer. d=O is displayed. Range not level. Poor baking results. The door was left open and controls set for self-cleaning cycle. Close the door. Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent if rack and cabinet cutout flooring are not level. Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are square and level. Contact cabinet maker to correct problem. Entire over= does not operate. When the oven is first plugged in, or when the power supply to the oven has been interrupted, the display will flash. The oven cannot be programmed until the clock is set. Be sure electrical cord is securely connected into the electrical junction box. Cord/plug is not installed and/or connected, Cord is not supplied with oven, Contact Sears or another qualified servicer, ii.i.l i.i........ Service wiring not complete, Contact Sears or another qualified servicer, Power outage, Check house lights to be sure, Call your local electric company, Short in cord/plug. Replace cord/plug. Controls are not set properly, See instructions under Setting Oven Controls to set the controls, House fuse has blown or circuit breaker has tripped immediately following installation. House fuse may not be fully engaged, Check fuse and screw or engage circuit breaker securely, House fuse has blown or circuit breaker has tripped after the oven has been installed and previously operating, Call Sears or another qualified servicer, Oven light does not work. Burned-out or loose bulb. Follow the instructions under Changing Oven Light to replace or tighten the bulb, Fan noise during cooking operation, A cooling fan may automatically turn on and off to cool internal parts. This is normal, and the fan may continue to run even after oven is turned off. 21