Kenmore 4810 Installation Instructions - Page 4

Location, Of Your, Washer

Get Kenmore 4810 - 3.5 cu. Ft. I.E.C. High-Efficiency Washer PDF manuals and user guides View all Kenmore 4810 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

LOCATION OF YOUR WASHER DO NOT INSTALL YOUR WASHER: I. In an area exposed to dripping water or outside weather conditions. The ambient temperature should never be below 60 ° F (15.6 ° C) for proper washer (detergent breakdown) operation. 2. In an area where it will come in contact with curtains or drapes. 3. In an area (garage or garage-type building) where gasoline of other flammables are kept or stored (including automobiles). 4. On carpet. Floor MUST be solid with a maximum slope of 1/2 in. per foot (1.27 cm per 30.5 cm). To ensure vibration or movement does not occur, reinforcement of the floor may be necessary. IMPORTANT MINIMUM INSTALLATION CLEARANCES When installed in alcove or closet: Sides, Rear = 0 in. (0 cm) Top = 0 in. (0 cm) When installed in closet: Front = I in. (2.54 cm) Closet door ventilation required: 2 Iouvered openings each 60 in2(387 cm2), 3 in. (7.6 cm) from top and bottom of door. UNPACKING 1. Cut the shipping carton along the dotted line along the bottom. Remove the carton. 2. Using a rug, blanket or piece of cardboard to protect the floor, lay the washer on it's back. 3. Remove and save the styrofoam base and shipping plug. Base Shipping Plug

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
LOCATION
OF YOUR
WASHER
DO NOT INSTALL YOUR WASHER:
I.
In an area exposed to dripping water or outside weather conditions. The ambient temperature
should never be below 60 ° F
(15.6 ° C) for proper washer (detergent breakdown)
operation.
2.
In an area where it will come in contact with curtains or drapes.
3.
In an area (garage or garage-type building) where gasoline of other flammables are kept or stored (including automobiles).
4.
On carpet. Floor MUST
be solid with
a maximum slope of 1/2 in. per foot
(1.27 cm per 30.5 cm). To ensure vibration
or
movement does not occur, reinforcement
of the floor may be necessary.
IMPORTANT
MINIMUM
INSTALLATION CLEARANCES
When installed
in alcove
or closet:
Sides, Rear = 0 in. (0 cm)
Top = 0 in. (0 cm)
When installed
in closet:
Front = I in. (2.54 cm)
Closet door ventilation required: 2 Iouvered openings each 60 in2(387 cm2), 3 in. (7.6 cm) from top and bottom of door.
UNPACKING
1.
Cut the shipping carton along the dotted
line along the bottom.
Remove the carton.
2.
Using a rug, blanket or piece of cardboard to protect the floor, lay the washer on it's back.
3.
Remove and save the styrofoam base and shipping plug.
Shipping
Base
Plug