Kenmore 6472 Use and Care Guide - Page 8
Removal, and Reversal, continued
View all Kenmore 6472 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Door Removal and Reversal Instructions (continued) NOTE: Some models have "pocket" handles, which are recessed into the sides of the doer. On these models, only the hinges will need to be reversed. TO REMOVE FREEZER HANDLE: , HandUesmay be easier to reverse while doors are off,, 1. Remove two screws attaching handUe to bottom of freezer door, 2, Swing bottom of handUeaway from the door and slide handUestraight up and off of dovetail button, 3, Remove screw and dovetail button and install on other side. moving hoUepHugsfrom corresponding noUesto opposite side, TO ATTACH FREEZER HANDLE: 1. Start with handUeoffset away from door, PUacetop of handUeover dovetail button swing handle into an upright position and pull downward locking it into place, 2, Secure bottom of handle with two screws removed earlier, Plug / / Lock Handle over TRIM REMOVAL (FULL-LENGTH TRIM MODELS ONLY) In some models, the refrigerator door has a full length trim piece which continues from the bottom of the handle to the bottom of the door, The top of the trim fits around the base of the handle, An adhesive "trim lock" is positioned about halfway down, The bottom of the trim is held in place by either an adhesive trim lock, or a trim lock with two prongs inserted into a hole on the face of the door, TO REMOVE TRIM: 1. Remove trim by gently pulling trim lock areas out and away from door. 2. When trim is free from door, slide the trim straight down and away from base of handle. NOTE: For models with short handle triml remove by sliding trim straight down and off of handle biaCket. TO REMOVE REFRIGERATOR HANDLE: (Handles may be easier to reverse while doors are off,) 1, Remove two screws attaching handle to top of refrigerator door, 2, Swing top of handle away from door and slide handle down and off of dovetail button, 3, Remove screw and dovetail button and install on other side, moving hole plugs from corresponding holes to opposite side, TO ATTACH REFRIGERATOR HANDLE: 1. Start with handle offset away from door. Place bottom of handle over dovetail button, swing handle into an upright position and pull upward, locking it into place. 2. Secure top of handle with screws. TO ATTACH TRIM: 1. Slide both trim locks out of trim. 2. Insert new adhesive trim locks contained in your literature pack. NOTE_ Trim lock must be removed and installed by did!ng over the two donut shaped areas. 3, Install trim to handle by sliding over base of handle, Carefully align trim and press down at trim lock locations, 4, Replace hole plug on opposite side, Use rubbing alcohol to remove any adhesive residue from old trim lock locations, t Dovetai! Trim Lock Handle over im Lock Lock