Kenmore 6965 Quick Start Guide - Page 2

Times

Page 2 highlights

Formodewlsitha FabriCcarecontroklnoby,oumayusethiscontrotolselectthedryintgemperatuthraemt atchethsefabrics inyoulroadT. hefollowintagblelistssuggestaeudtomoistusrensinogrtimedrysettingfosrvarioulosadsT.hisisonlyaguide. FABRIC CARE/ TEMPERATURE LOAD TYPE COTTON/TOWELS HIGH NORMAL MEDIUM HIGH DELICATE LOW CASUAL MEDIUM Heavyweight items - Quilts, towels, jeans, cottons, bedspreads Medium-weight items - Shirts, sheets, slacks, play clothes, cloth diapers Lightweight items - Lingerie, blouses, dresses, synthetics, and blends Medium-weight items - synthetics (polyester, acrylic), skirts, sweaters, slacks *Reset time as needed to allow items to dry completely. AUTO MOISTURE SENSING More Dry Normal Dry Less Dry Normal Dry TIMED DRY SETTING* 50-70 minutes 30-50 minutes 20-40 minutes 30-50 minutes Auto Moisture Sensing When you are using the Auto Moisture Sensing Cycle, the dryness of the load is determined by two metal strips (sensors) located on the inside of the dryer. The metal strips help "feel" the amount of moisture left in the clothes as they pass. When there is moisture left in the clothes, the Cycle Control knob will not advance. As clothes begin to dry, the amount of water left in the clothes decreases, and the timer advances through the remainder of the cycle. When the selected dryness level is reached, the dryer goes into a cool down period of up to 10 minutes. If the load is drier than you like, you may select a setting closer to Less Dry the next time you dry a similar toad. If a load is not as dry as you like, you may complete drying using a Timed cycle. You may also select a setting closer to More Dry the next time you dry a similar load. Timed Dry This cycle may be used to get up to 90 minutes of heated drying time. The heating cycle is followed by a coot down period of up to 10 minutes. Air Fluff You may use the Air Fluff cycle to get up to 30 minutes of drying time in room temperature air. This setting should be used for items such as plastics, rubber, and heat-sensitive fabrics. J WRIIRL£ llaBI I WRINKLE GUARD ®I helps smooth out wrinkles that may form when clothes are not removed promptly at the end of a cycle. WRINKLE GUARD _ I continuously tumbles the load, without heat, for 40 minutes unless you open the dryer door. uring WRINKLE GUARD _ I, the End of Cycle Signal will sound every 5 minutes unless the signal is turned off. 1 TIIIILESIIITINI - LIII IIY TIMES,LIAI NIT IIYINI Before you call service...check for the following. Is the lint screen clogged with lint? • Clean the lint screen before each toad. Is the exhaust vent or outside exhaust hood clogged with lint? • Lint should be cleaned out of the exhaust vent at least once every 2 years. See the Use and Care Guide for complete details. W10035733A © 2008 Sears Brands, LLC ® Registered Trademark / TMTrademark / SMService Mark of Sears Brands, LLC 8/o8 Printed in U.S.A.

  • 1
  • 2
  • 3
  • 4

Formodels
withaFabric
Carecontrol
knob,
youmayuse
thiscontrol
toselect
thedrying
temperature
that
matches
thefabrics
inyour
load.
The
following
table
listssuggested
automoisture
sensing
ortimedrysettings
forvarious
loads.
This
isonlyaguide.
FABRIC
CARE/
AUTO MOISTURE
TIMED DRY
TEMPERATURE
LOAD TYPE
SENSING
SETTING*
COTTON/TOWELS
Heavyweight
items - Quilts, towels,
More Dry
50-70
HIGH
jeans, cottons, bedspreads
minutes
NORMAL
Medium-weight
items - Shirts,
Normal Dry
30-50
MEDIUM
HIGH
sheets, slacks, play clothes,
minutes
cloth diapers
DELICATE
Lightweight items - Lingerie, blouses,
Less Dry
20-40
LOW
dresses, synthetics,
and blends
minutes
CASUAL
Medium-weight
items - synthetics
Normal Dry
30-50
MEDIUM
(polyester, acrylic), skirts, sweaters, slacks
minutes
*Reset time as needed to allow items to dry completely.
Auto
Moisture
Sensing
When you are using the Auto Moisture Sensing Cycle,
the dryness of the load is determined by two metal strips
(sensors) located on the inside of the dryer. The metal
strips help "feel" the amount of moisture left in the clothes
as they pass. When there is moisture left in the clothes, the
Cycle Control knob will not advance. As clothes begin to
dry, the amount of water left in the clothes decreases, and
the timer advances through the remainder of the cycle.
When the selected dryness level is reached, the dryer
goes into a cool down period of up to 10 minutes.
If the load is drier than you like, you may select a setting
closer to Less Dry the next time you dry a similar toad. If
a load is not as dry as you like, you may complete drying
using a Timed cycle. You may also select a setting closer
to More Dry the next time you dry a similar load.
Timed
Dry
This cycle may be used to get up to 90 minutes of heated
drying time. The heating cycle is followed by a coot down period
of up to 10 minutes.
Air
Fluff
You may use the Air Fluff cycle to get up to 30 minutes of drying
time in room temperature air. This setting should be used for
items such as plastics, rubber, and heat-sensitive fabrics.
WRIIRL£ llaBI
I
WRINKLE GUARD ®I helps smooth out wrinkles that may form when clothes are not removed promptly at the end of a cycle.
WRINKLE GUARD _ I continuously tumbles the load, without heat, for 40 minutes unless you open the dryer door.
uring WRINKLE GUARD _ I, the End of Cycle Signal will sound every 5 minutes unless the signal is turned off.
J
1
TIIIILESIIITINI
- LIII
IIY
TIMES,
LIAI
NIT
IIYINI
Before
you call service...check
for
the
following.
Is the lint screen clogged with lint?
Is the exhaust vent or outside exhaust hood clogged with
• Clean the lint screen before each toad.
lint?
• Lint should be cleaned out of the exhaust vent at least once
every 2 years.
See the Use and Care Guide for complete details.
W10035733A
8/o8
© 2008
Sears Brands,
LLC
® Registered
Trademark
/
TMTrademark
/
SMService
Mark of Sears Brands,
LLC
Printed
in U.S.A.