Kenmore 6972 User Instructions - Page 6
Dryer
View all Kenmore 6972 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Usethedryer ackto dryitemssuchassweaterasndpillows withouttumblingT.hedrumturnsb, uttherackdoesnotmove. Ifyourmodedloesnothavea dryeracky, oumaybeableto purchasoeneT. ofindoutwhetheyrourmodeal llowdsryerack usagaendtoobtainorderinignformatiopnle, asreefetrotheback pageofthismanuaolrcontactthedealefr omwhomyou purchaseydourdryer. NOTEY: oumusrtemovderyerackfornormatul mblingD.onot useautomatcicycleswiththedryerack. TUMBLE FREE TM Non-Heated Dryer Rack Use with 29" (73.7 cm) wide dryers. Air circulates in a concentrated pattern over and around clothes to allow efficient and uniform drying. TUMBLE FREE TM Heated Dryer Rack Use with 27" (69 cm) wide dryers. Air circulates in a concentrated pattern over, under and through clothes, significantly reducing drying time. Tousethedryerrack: 1. 29" (73.7 cm) Wide Dryer Slide rear pegs into the dimples on the back wall of the dryer. Lower the front legs to rest on the dryer opening. 27" (69 cm) Wide Dryer Do not remove lint screen. Slide dryer rack over the bottom of the dryer door opening. Push down to secure it on the frame. 2. Put wet items on the rack. Leave space between items so air can reach all surfaces. Do not allow items to hang over the edge of the rack. Close the door. 3. Select cycle and temperature to match the fabrics in your load. Items containing foam, rubber, or plastic must be dried on a clothesline or by using an air cycle. Refer to the following table. 4. Start the dryer. Reset time to complete drying, if needed. Rack Dry Cycle Temp Time Washable wool items (block to shape and lay flat on rack) Timed Dry Low 20 rain. Stuffed toys or pillows (cotton Timed or polyester fiber filled) Dry Low 20 min. Stuffed toys/pillows (foam rubber filled) Air None (no heat) 20 - 50 min. DRYER CARE Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air. Every Load Cleaning Style 1: 1. The lint screen is located on top of the dryer. Pull the lint screen toward you. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove. Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from dryer. Place dryer at least 18 inches (46 cm) above the floor for a garage installation. Failure to do so can result in death, explosion, or fire. L_t c>o_})®n Clean the lint screen before each load. A screen blocked by lint can increase drying time. IMPORTANT: • Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics. • If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. 2. Push the lint screen firmly back into place. Style 2: 1. The lint screen is located in the door of the dryer. Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove. 2. Push the lint screen firmly back into place.