Kenmore 7452 Use and Care Guide - Page 6

l stallatiot7 o Connecting Optional Ice Maker To Water Supply To avoid electric shock, which can cause death or severe personal injury, disconnect the refrigerator from electrical power before connecting a water supply line to the refrigerator. To Avoid Property Damage: - Copper tubing is recommended for the water supply line. Water suppJy tubing made of 1A" plastic is not recommended since it greatJy increases the potentiaJ for water leaks. Manufacturer will not be responsible for any damage if plastic tubing is used for supply line. - DO NOT install water supply tubing in areas where temperatures fall below freezing. - Chemicals from a maffunctioning softener can damage the ice maker, if the ice maker is connected to soft water, ensure that the softener is maintained and working properly. iMPORTANT: Ensure that your water supply line connections comply with all local plumbing codes, Before installing The Water Supply Line, You Will Need Basic Toots: adjustable wrench, flat=blade screwdriver, and Phillips TM screwdriver o Access to a household cold water line with water pressure between 20 and 120 psi, A water supply line made of ¼ inch (6,4 mm) OD, copper tubing or braided water line, To determine the length of copper tubing needed, you wiii need to measure the distance from the ice maker inlet valve at the back of the refrigerator to your cold water pipe, Then add approximately 7 feet (2,1 meters), so the refrigerator can be moved out for cleaning (as shown), A shutoff valve to connect the water supply line to your household water system, DO NOT use a self-piercing type shutoff valve, o A compression nut and ferrule (sleeve) for connecting the water supply line to the ice maker inlet valve, To Connect Water Supply Line To Ice Maker/nlet Valve 1. Disconnect refrigerator from electric power source. 2, Place end of water supply line into sink or bucket, Turn ON water supply and flush supply line until water is clear, Turn OFF water supply at shut off valve, 3, Unscrew plastic cap from water valve inlet and discard cap, 4, Slide brass compression nut, then ferrule (sleeve) onto water supply line, as shown, 5, Push water supply line into water valve inlet as far as it wiii go (¼ inch), Slide ferrule (sleeve) into valve inlet and finger tighten compression nut onto valve, Tighten another half turn with a wrench; DO NOT over tighten, 6, With steel clamp and screw, secure water supply line to rear panel of refrigerator as shown, 7, Coil excess water supply line (about 2aSturns) behind refrigerator as shown and arrange coils so they do not vibrate or wear against any other surface, 8, Turn ON water supply at shutoff valve and tighten any connections that leak, 9, Reconnect refrigerator to electrical power source, 10, To turn ice maker on, lower wire signal arm (see ice maker front cover for ON/ OFF position of arm), Plastic Water Tubing to Ice Maker Clamp Brass Compression (Sleeve) water line Water Valve from household water supply (Include enough tubing in loop to allow moving refrigerator out for cleaning.) iMPORTANT: !t takes approx!mate!y 24 hours for the ice maker to begin producing ice, Air in new plumbing lines may cause ice maker to cycle two or three times before making a ful! tray 0f !ce, New plumbing may cause ice to be discQ!ored or have poor flavor. Discard ice made during the first 24 hours.