Kenmore 7749 Use and Care Guide - Page 7

Before Using Your Range Assembly of Burner Heads & Burner Caps (for Deep Well Cooktop models only) Your appliance is shipped with the Burner Heads and Burner Caps in the correct locations. Packing material is located between the Burner Heads and the cooktop. a. Be sure to follow the installation instructions before installing and using your new appliance. b. Remove all packing tape from cooktop area. Remove all Burner Caps and Burner Heads. c. Discard all packing material located under Burner Heads. d. To replace Burner Heads & Caps, match the letters located under center of Burner Caps with the letters located inside Burner Heads (Fig. 1). e. Match the letters stamped on Burner Skirts with Burner Heads and Burner Caps (See Fig. 1). Replace the Burner Heads and Caps on cooktop (See Fig. 2). Carefully align the Electrodes into slot or hole of each Burner Head (Fig. 3). Note: The Burner Heads should sit flat on Cooktop Burner Skirts. f. Unpack Burner Grates and position on the cooktop. Burner Skirt Fig. 1 Fig. 2 Electrode must align into slot or hole for Simmer Burner Head Fig, 3