Kenmore 7834 Use and Care Guide - Page 17

Adjusting, Control, Settings, Dispenser

Page 17 highlights

• Dispenser Light: When the Light button is pressed, the display will indicate the selected function. Press the LIGHT button once to turn On/Off the dispenser Lamp. When water dispenser Pad is used also the dispenser light will be illuminated. • Display Off Mode: Initially the display Off mode is enable. After 20 seconds of control panel inactivity the display is turned off. It display Off mode press and hold ULTRA ICE and FREEZER buttons over 5 seconds until the lights tilt. To activate this mode again execute previous method. Display Off mode does not affect the temperature control setting of the unit. ADJUSTING CONTROL SETTINGS Give the refrigerator time to cool down completely before adding food. It is best to wait 24 hours before you put food into the refrigerator. The mid-settings indicated in the previous section should be correct for normal household refrigerator usage. The controls are set correctly when milk or juice is as cold as you like and when ice cream is firm. The refrigerator control functions as the thermostat for the entire appliance (refrigerator and freezer sections.) The higher the number setting, the longer the compressor will run to keep the temperature colder. The freezer control adjusts the cold air flow from the freezer to the refrigerator. Setting the freezer control to a lower temperature keeps more cold air in the Freezer compartment to make it colder. If you need to adjust temperatures in the refrigerator or freezer, start by adjusting the refrigerator first. Wait 24 hours after the refrigerator adjustment to check the freezer temperature. If it is too warm or too cold, then adjust the freezer control as well. Use the settings listed in the chart below as a guide. Always remember to wait at least 24 hours between adjustments. CONDITION/REASON: RECOMMENDED ADJUSTMENT: REFRIGERATOR section too warm " Door opened often ,, Large amount of food added • Room temperature very warm Turn REFRIGERATOR control to next higher number, wait 24 hours, then re-check FREEZER section too warm/ ice not made fast enough " Door opened often ,, Large amount of food added • Very cold room temperature (can't cycle often enough) " Heavy ice usage " Air vents blocked by items REFRIGERATOR section too cold • Controls not set correctly for your conditions Turn FREEZER control to next higher number, wait 24 hours, Then re-check Move items out of airstream Turn REFRIGERATOR control to next lower number, wait 24 hours, then re-check FREEZER section too cold • Controls not set correctly for your conditions Turn FREEZER control to next lower number, wait 24 hours, then re-check WATER DISPENSER Push the dispenser pad with a glass until you hear a click to get cold water. Dispenser Switch Push Tray can be easily removed by pressing and pulling it. Tilt up the front of tray slightly and snap the ribs into the holes to replace the tray. Important: Whenthe refrigeratoris firstconnectedto thewater supply, it is necessaryto dispense2.5 gallons(9.46liters)of water to remove Trappedair fromthe system.(Approximately5 minutes).This is necessary to avoidpossibleleaks or problemswhendispensingwater. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34

• Dispenser
Light:
When the Light
button
is
pressed,
the
display will
indicate the selected function.
Press the LIGHT button once to turn On/Off the
dispenser
Lamp.
When water dispenser
Pad is used also the dispenser
light will be illuminated.
Display
Off Mode:
Initially the display Off mode is enable.
After 20 seconds of control panel inactivity
the
display is turned off.
It display Off mode press and hold ULTRA ICE and
FREEZER
buttons over 5 seconds until the lights tilt.
To activate this mode again execute previous
method.
Display
Off mode does not affect the temperature
control setting of the unit.
ADJUSTING
CONTROL
SETTINGS
Give the refrigerator
time to cool down completely
before
adding food. It is best to wait 24 hours before you put
food into the refrigerator. The mid-settings
indicated in the
previous
section should be correct for normal
household
refrigerator
usage. The controls are set correctly when
milk or juice
is as cold as you like and when ice cream
is firm.
The refrigerator
control functions
as the thermostat
for the
entire appliance
(refrigerator
and freezer sections.) The
higher the number setting, the longer the compressor
will
run to keep the temperature
colder. The freezer control
adjusts the cold air flow from the freezer to the
refrigerator.
Setting the freezer control to a lower
temperature
keeps more cold air in the Freezer
compartment
to make it colder.
If you need to adjust temperatures
in the refrigerator
or
freezer, start by adjusting the refrigerator
first. Wait 24
hours after the refrigerator
adjustment
to check the
freezer temperature.
If it is too warm or too cold, then
adjust the freezer control as well.
Use the settings
listed in the chart below as a guide.
Always
remember to wait at least 24 hours between
adjustments.
CONDITION/REASON:
REFRIGERATORsection
too
warm
" Door opened often
,, Large amount of food added
• Room temperature very warm
RECOMMENDED
ADJUSTMENT:
Turn
REFRIGERATOR
control to next
higher number,
wait 24 hours,
then re-check
FREEZER section
too
warm/
ice not made
fast
enough
" Door opened often
,, Large amount of food added
• Very cold room temperature
(can't cycle often enough)
" Heavy ice usage
" Air vents blocked by items
REFRIGERATORsection
too
cold
• Controls not set correctly for
your conditions
Turn FREEZER
control
to next
higher
number,
wait 24 hours,
Then re-check
Move items out of
airstream
Turn
REFRIGERATOR
control to next
lower number,
wait 24 hours,
then re-check
FREEZER section
too
cold
• Controls not set correctly for
your conditions
Turn FREEZER
control to
next
lower number,
wait 24 hours,
then re-check
WATER
DISPENSER
Push the dispenser
pad with
a glass until you hear a click
to get cold water.
Tray can be easily removed
by pressing and pulling it.
Tilt up the front of tray slightly
and snap the ribs into the holes
to replace the tray.
Dispenser
Switch
Push
17
Important:
Whentherefrigerator
is firstconnectedto thewatersupply,
it is necessaryto dispense2.5 gallons(9.46liters)of waterto remove
Trappedair fromthesystem.(Approximately5minutes).Thisisnecessary
toavoidpossibleleaksorproblemswhendispensingwater.