Kenmore 8041 Installation Instructions - Page 6

MOBILE HOME INSTALLATION 1. DryerMUSTbe exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. Metal ducting must be 4 inches (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred. 2. If dryer is exhausted through the floor and area beneath the mobile home is enclosed, the exhaust system MUST terminate outside the enclosure with the termination securely fastened to the mobile home structure. 3. When installing a gas dryer into a mobile home, a provision must be made for outside make up air. This provision is to be not less than twice the area of the dryer exhaust outlet. 4. This dryer MUST be fastened to the floor. Mobile Home Installation Kit No. 169840 is available from your dealer. 5. Refer to pages 2 and 3 for other important venting requirements. 6. Installation MUSTconform to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR-Part 32-80) or when such standard is not applicable, with American National Standard for Mobile Homes. In Canada, the CSA Z240 is applicable. The dryer is designed under ANSI Z 21.5.1 for HOME USE ortly. UNDER COUNTER & STACK MODELS ROUGH-IN DIMENSIONS [3 ELECTRICCONNECTION 2 9/16=---_ (63 cra) _-_ 131/2" -_ UNDER COUNTER 34 5/8" (87.9 cm) (34.4 cm) I 36" (91.5 cm) T 33/4" (9.5 crn) I 3/8" (0.96 cm) DIA. GAS PIPE 1"(2.54 cm) REAR VIEW Correct 471/2" (120.7 cm) Correct DO © Correct incorrect DOOR OPEN 90 ° B 6 4 318" (11.1 cm) _-_ OPTIONAL VENT KNOCKOUT_,_ - 27" (68.6 crn) SIDE VIEW 3 3/4" (9.5 crn)