Kenmore 9787 Use and Care Guide - Page 5

Kenmore 9787 - Elite HE3 7.0 cu. Ft. Gas Dryer Manual

Page 5 highlights

Parts needed Check local codes and with gas supplier. Check existing gas supply, electrical supply and venting. Read "Electrical Requirements," "Gas Supply Requirements" and "Venting Requirements" before purchasing parts. • For close-clearance installations between 31,5" (80,01 cm) and 37" (93.98 cm), see "Plan Vent System" section for venting requirements. Explosion Hazard such as Keep flammable materials and vapors, gasoline, away from dryer. I_37" (93.98 crn) --_1 Place dryer at least 18 inches (46 cm) above the floor for a garage installation. Failure to do so can result in death, explosion, or fire. Mobile home installations require special parts (listed following) available for purchase from your local Sears store or Sears Service Center. For further information, please call 1-800-4-MY-HOME ® (1-800-469-4663). • Mobile Home Installation Kit. Ask for Part Number 346764. • Metal exhaust system hardware. You will need • A location that allows for proper exhaust installation. A gas dryer must be exhausted to the outdoors. See "Venting Requirements." A grounded electrical outlet located within 2 ft (61 cm) of either side of the dryer. See "Electrical Requirements." A sturdy floor to support the total dryer weight of 200 Ibs (90.7 kg). The combined weight of a companion appliance should also be considered. A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. (If slope is greater than 1" [2.5 cm], install Extended Dryer Feet Kit, Part No. 279810.) Clothes may not tumble properly and automatic sensor cycles may not operate correctly if dryer is not level. • For a garage installation, you will need to place the dryer at least 18" (46 cm) above the floor. If using a pedestal, you will need 18" (46 cm) to the bottom of the dryer. • Are you placing the dryer on a pedestal? You have the option of purchasing pedestals of different heights separately for this dryer. You may select a 10" (25.4 cm) pedestal or a 15.5" (39,4 cm) pedestal with a storage drawer. The pedestal will add to the total height of the dryer for a total height of approximately 46" (116.8 cm) or 51,5" (130.8 cm), respectively. For a garage installation, you will need to place the 10" (25.4 cm) pedestal at least 9" (22.9 cm) above the floor. You will need to place the 15.5" (39.4 cm) pedestal at least 3" (7.6 cm) above the floor. • Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended. The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Optional pedestal (15.5" [39.4 cm] model shown) Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector. NOTE: No other fuel-burning same closet as a dryer. Installation clearances The location must be large enough to allow the dryer door to open fully, appliance can be installed in the To order, call your local Sears store. For further information, please call 1-800-4-MY-HOME ®(1-800-469-4663}. Pedestal Height Color White White Part Number 46822 57822 10" (25.4 cm) 15.5" (39.4 cm)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52

Parts
needed
Check
local codes
and with gas supplier.
Check
existing
gas
supply,
electrical
supply
and venting.
Read "Electrical
Requirements,"
"Gas Supply
Requirements"
and "Venting
Requirements"
before
purchasing
parts.
For close-clearance
installations
between
31,5"
(80,01 cm)
and 37"
(93.98 cm), see "Plan Vent System"
section
for
venting
requirements.
I_-
37"
--_1
(93.98
crn)
Mobile
home installations
require special
parts (listed following)
available
for purchase
from your local
Sears store
or Sears
Service
Center.
For further
information,
please
call
1-800-4-MY-HOME
®
(1-800-469-4663).
Mobile
Home
Installation
Kit. Ask for Part Number
346764.
Metal
exhaust
system
hardware.
Are you placing
the dryer on a pedestal?
You have the option
of
purchasing
pedestals
of different
heights
separately
for this dryer.
You may select a 10" (25.4 cm) pedestal
or a 15.5" (39,4 cm)
pedestal
with a storage
drawer. The pedestal
will add to the total
height
of the dryer for a total
height
of approximately
46" (116.8 cm) or 51,5" (130.8
cm), respectively.
For a garage installation,
you will need to place the 10" (25.4 cm)
pedestal
at least 9" (22.9 cm) above
the floor.
You will need to
place the 15.5" (39.4 cm) pedestal
at least 3" (7.6 cm) above
the
floor.
Optional
pedestal
(15.5" [39.4
cm] model
shown)
To order, call your
local Sears store.
For further
information,
please
call 1-800-4-MY-HOME
®(1-800-469-4663}.
Pedestal
Height
Color
Part
Number
10" (25.4 cm)
White
46822
15.5"
(39.4 cm)
White
57822
Explosion
Hazard
Keep
flammable
materials
and vapors,
such
as
gasoline,
away
from
dryer.
Place
dryer
at least
18
inches
(46 cm)
above
the floor
for
a garage
installation.
Failure
to
do
so
can result
in death,
explosion,
or
fire.
You
will
need
A location
that
allows for proper
exhaust
installation.
A gas
dryer must
be exhausted
to the outdoors.
See "Venting
Requirements."
A grounded
electrical
outlet
located
within
2 ft (61 cm) of
either side of the dryer. See "Electrical
Requirements."
A sturdy
floor
to support
the total
dryer weight
of
200 Ibs (90.7 kg). The combined
weight
of a companion
appliance
should
also be considered.
A level floor
with a maximum
slope of 1" (2.5 cm) under entire
dryer. (If slope
is greater than
1" [2.5 cm], install Extended
Dryer Feet Kit, Part No. 279810.)
Clothes
may not tumble
properly
and automatic
sensor cycles
may not operate
correctly
if dryer is not level.
For a garage installation,
you will need to place the dryer at
least 18" (46 cm) above
the floor.
If using a pedestal,
you will
need
18" (46 cm) to the bottom
of the dryer.
Do not operate
your
dryer at temperatures
below 45°F (7°C). At
lower temperatures,
the dryer might
not shut off at the end of an
automatic
cycle.
Drying times
can be extended.
The dryer must not be installed
or stored
in an area where
it will
be exposed
to water
and/or
weather.
Check
code
requirements.
Some codes
limit,
or do not permit,
installation
of the dryer in garages,
closets,
mobile
homes,
or
sleeping
quarters.
Contact
your
local building
inspector.
NOTE:
No other fuel-burning
appliance
can be installed
in the
same closet
as a dryer.
Installation
clearances
The location
must be large enough
to allow the dryer door to
open fully,