Kenwood 00271-06000 User Manual - Page 11

Loudness Compensating for low and high tones during low volume. Press the [LOUD] knob for at least 1 second. Each time the knob is pressed for at least 1 second the Loudness turns ON or OFF. When it's ON, "LOUD ON" is displayed. Audio Control 1 Select the source for adjustment Press the [POWER] button. 2 Enter Audio Control mode Press the [AUDIO] knob. 3 Select the Audio item for adjustment Press the [AUDIO] knob. Each time the knob is pressed the audio items that can be adjusted switch as shown below. 4 Adjust the Audio item Turn the [4] / [¢] knob. Audio Item Sub woofer level* Bass Middle Treble Balance Fader Display "SW Level" "Bass" "Middle" "Treble" "Balance" "Fader" Range -15 - +15 -8 - +8 -8 - +8 -8 - +8 Left 15 - Right 15 Rear 15 - Front 15 Audio Setup 1 Select the source for adjustment Press the [POWER] button. 2 Enter Audio Setup mode Press the [AUDIO] knob for at least 1 second. 3 Select the setup item for adjustment Press the [AUDIO] knob. Each time the knob is pressed the items that can be adjusted switch as shown below. 4 Adjust the Audio Setup item Turn the [4] / [¢] knob. Setup Item System Q* Volume offset Display "Flat/User/ Rock/Pops/ Easy/Top40/ Jazz" "V- Offset" Range [Sound setting] [Flat/User memory/ Rock/Pops/ Easy/Top40/ Jazz] -8 - ±0 • *System Q: You can recall the best sound setting preset for different types of music. • User memory: The values set on the (page 11). • Volume offset: Each source's volume can be set as a difference from the basic volume. 5 Exit Audio Setup mode Press the [AUDIO] knob for at least 1 second. • If you make no button operation for 10 seconds, this function is automatically canceled. • * This mode is available only when (page 13) is ON and (page 21) is set to "SWPRE Sub-W". 5 Exit Audio Control mode Press the [AUDIO] knob for at least 1 second. • If you make no button operation for 10 seconds, this function is automatically canceled. English | 11