Kenwood 6404 Owner's Manual (pdf) - Page 4
Controls
UPC - 019048176110
View all Kenwood 6404 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Controls p q t r r s 40W 15W 1 A ch FILTER switch This switch allow filtering of the speaker output signals. • OFF position: The original sound without filtering is output. • HPF (High Pass Filter) position: Only frequencies of 80 Hz or higher are output. (Frequencies below 80 Hz are cut.) 2 B ch FILTER switch This switch allow filtering of the speaker output signals. • OFF position: The original sound without filtering is output. • LPF (Low-Pass Filter) position: The filter outputs the band of lower frequencies than the frequency set with the "LPF FREQUENCY" control. The speaker output is automatically turned monaural (L+R) and the gain is enhanced. 3 INPUT SENSITIVITY control (A.ch/ B.ch) Set this control according to the pre-output level of the center unit connected with this unit, or to the maximum power output of the genuine-accessory car stereo. Use the diagram on the right as a guide. The sensitivities of amplifiers A and B can be adjusted independently. 4 B ch LPF FREQUENCY control Sets the cutoff frequency when the "B ch FILTER" switch is set to "LPF". 5 Power indicator When the power is turned on, the Power indicator lights. If the Power indicator does not light when the power is turned on, the protection function may be activated. Check whether there is any indication of trouble. Refer to (page 2). 4 English