Kenwood CA-PLT14SG Operation Manual - Page 2
The CA-PLT14SG plate is made to mount amplifiers, with a maximum dimension of 8.5 W x 7 D x 2 H,
View all Kenwood CA-PLT14SG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
The CA-PLT14SG plate is made to mount amplifiers with a maximum dimension of 8.5" W x 7" D x 2" H (216mm x 178mm x 51mm). Installation procedure 1. Over the top of the radio, pull up to release each wire harness from the black plate via the factory "Christmas tree" fasteners. If your bike has factory GPS, the small square antenna will need to be relocated just behind the voltmeter as shown in Fig 1.1 below. Figure 1.1 - The white circle shows the new location for the GPS Antenna if your bike came factory equipped with this feature. 2. Remove the four factory T-20 "Torx" screws that go through the top of the black plate and into the top of the radio. Set these screws aside for now. 3. Sit the main amplifier plate over the top of the radio, noting the 4 holes in the plate will line up with the 4 holes left by the factory screws just removed. The factory screws will now go through the main mounting plate, through the black plate over the top of the radio, and into the top of the radio. 4. Locate the Velcro® that came in the box and stick it to the bottom plate of the amp being installed. You can now "stick" the amp to the mounting plate just installed. Depending on the amp you are installing, you can use the "tabs" on the CA-PLT14SG to re-secure the wire harnesses that were held in place using the "Christmas Tree Fasteners." For updated information (the latest Instruction Manual, etc.), please visit the following website: https://manual.kenwood.com/en_contents/search/