Kenwood CA-PLT14SG3 Operation Manual - Page 2

FLH Side Plate Installation Instructions Installation procedure 1. With your ignition switch in the "OFF" position, remove your outer fairing/headlamp assembly and set it aside. Refer to a service manual if you need help with this. NOTE: Placing a towel on the front fender can help prevent scratches or "dings" from dropped tools or fasteners, etc. 2. Clutch Side Speaker Cabinet Removal: The images below show the 8 fasteners that will need to be removed to allow the clutch side cabinet to be removed from the bike. If your bike has the CB module, (mounted "sideways" on the clutch side cabinet), undo the antenna cable and main harness. The CB module will stay attached to the clutch side cabinet when removed. Undo the speaker wire plugs going into the cabinet (pink & pink with black stripe wires). If your bike had the CB Module, remove its mounting plate from the speaker cabinet. Note: Brake Side Shown, But Fastener Location is the Same for Clutch Side Figure 1.1 - Side View of Cabinet Figure 1.2 - Back View of Cabinet 3. Attaching the Main Plate to the Speaker Cabinet: On the side of the cabinet, you will see a threaded insert and a locating post as seen in Fig 1.3. Put the main plate on the cabinet so one of the holes in the plate goes over the locating post, and the other sits over the threaded insert. If you removed a CB module from an Ultra, you can use the screw that secured that module to the speaker pod. If your bike did not have a CB module, use the machine screw that came in the kit to secure the side plate to the speaker cabinet. Fig 1.3 on the next page shows the plate correctly placed on the speaker cabinet. 2