Kenwood CR-ST100S Operation Manual - Page 37

Caution

Get Kenwood CR-ST100S PDF manuals and user guides View all Kenwood CR-ST100S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

1.17 Network connection - Please make sure that the firewall function is activated at your network access point (router). Con- sult your router's instruction manual. - If you do not want to set up a network connection, please do not run the setup wizard (see 3.8). 1.18 Remote control - Exposing the remote control sensor to direct sunlight or high-frequency fluorescent light may cause malfunction. In such cases, you should move the system to a different location to avoid such malfunction. - The supplied batteries are intended for functional testing and may have a limited lifetime. If the range of the remote control decreases, replace the old batteries with new ones. Caution! Risk of explosion if the batteries are replaced with the wrong type; - High or low extreme temperatures to which a battery may be exposed during use, storage or transportation; - Low air pressure at high altitude; - Replacing a battery with a wrong type that can bypass a fuse (e.g. with some lithium battery types); - Disposing of a battery in fire or a hot oven, or mechanically squeezing or cutting a battery; - Leaving a battery in an environment with extremely high temperatures, which can lead to an explosion or leakage of flammable liquids or gases; - A battery that is exposed to extremely low air pressure, which can lead to an explosion or the escape of flammable liquids or gases. 1.19 Automatic energy saving function The radio is equipped with an automatic energy saving function. This switches the device to standby mode within 15 minutes if it is played at a very low volume or if the radio is muted. Please note that the setting can´t be changed. EU Declaration of Conformity Hereby, JVCKENWOOD Corporation declares that the radio equipment type CR-ST100S complies with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following Internet address: http://www.kenwood.com/cs/eudoc/ Manufacturer: JVCKENWOOD Corporation 3-12. Moriyacho, Kanagawa-ku, Yokohama-shi, Kanagawa 221-0022, JAPAN Authorised Representative (EU): JVCKENWOOD EUROPE B.V. Amsterdamseweg 37, 1422 AC UITHOORN, THE NETHERLANDS 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
5
1.17 Network connection
- Please make sure that the firewall function is activated at your network access point (router). Con-
sult your router's instruction manual.
- If you do not want to set up a network connection, please do not run the setup wizard (see 3.8).
1.18 Remote control
– Exposing the remote control sensor to direct sunlight or high-frequency fluorescent light may
cause malfunction. In such cases, you should move the system to a different location to avoid such
malfunction.
– The supplied batteries are intended for functional testing and may have a limited lifetime.
If the range of the remote control decreases, replace the old batteries with new ones.
Caution!
Risk of explosion if the batteries are replaced with the wrong type;
- High or low extreme temperatures to which a battery may be exposed during use, storage or trans-
portation;
- Low air pressure at high altitude;
- Replacing a battery with a wrong type that can bypass a fuse (e.g. with some lithium battery
types);
- Disposing of a battery in fire or a hot oven, or mechanically squeezing or cutting a battery;
- Leaving a battery in an environment with extremely high temperatures, which can lead to an ex-
plosion or leakage of flammable liquids or gases;
- A battery that is exposed to extremely low air pressure, which can lead to an explosion or the
escape of flammable liquids or gases.
1.19
Automatic energy saving function
The radio is equipped with an automatic energy saving function. This switches the device to standby
mode within 15 minutes if it is played at a very low volume or if the radio is muted. Please note that
the setting can´t be changed.
EU Declaration of Conformity
Hereby, JVCKENWOOD Corporation declares that the radio equipment type CR-ST100S complies with
Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following
Internet address:
Manufacturer:
JVCKENWOOD Corporation
3-12. Moriyacho, Kanagawa-ku, Yokohama-shi, Kanagawa 221-0022, JAPAN
Authorised Representative (EU):
JVCKENWOOD EUROPE B.V.
Amsterdamseweg 37, 1422 AC UITHOORN, THE NETHERLANDS