Kenwood DDX-512 Installation Guide - Page 4
Connection - remote
UPC - 019048176516
View all Kenwood DDX-512 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Connection Ignition key switch If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. ACC A B A Ignition wire (Red) Car fuse box (Main fuse) Car fuse box Battery wire (Yellow) B Ground wire (Black) - C (To car chassis) C -+ Battery Antenna Cord Connect to the vehicle's parking brake detection switch harness. Parking sensor wire (Light Green) PRK SW For the sake of safety, be sure to connect the parking sensor. Connect to vehicle's reverse lamp harness when using the optional rear view camera. To steering remote Reveres sensor wire (Purple/White) Steering remote control input (Light Blue/Yellow) To use the steering wheel remote control feature, you need to an exclusive remote adapter (not supplied) matches your car is required. When this terminal is not in use, leave its cap on. Dimmer control wire (Orange/White) To car light control switch Connect to the terminal that is grounded when either the telephone rings or during conversation. To connect the Kenwood navigation system, consult your navigation manual. Mute wire (Brown) Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. When using the optional power amplifier, connect to its power control terminal. Motor antenna control wire (Blue) Power control wire (Blue/White) 4 | DDX512/DDX5032 If no connections are made, do not let the cable come out from the tab.