Kenwood DDX4058BT User Manual 1 - Page 38

Setting menu items • You cannot change settings (except ) when the unit is in standby. Menu item Selectable setting/item Initial: Underlined Fader/Balance Fader : Adjust the front and rear speaker output balance. ♦ F6 to R6; Initial 0 • When using a two-speaker system, set the fader to the center (0). Balance : Adjust the left and right speaker output balance. ♦ L6 to R6; Initial 0 Press [5/∞/2/3] or drag [ ] to adjust. • To clear the adjustment, press [Center]. Equalizer Change the sound mode or adjust and store the equalization for each source. (☞ page 31) ♦ Natural/Rock/Pops/Easy/Top40/Jazz/User Loudness You can activate/deactivate the loudness function. ♦ OFF : Cancels. ♦ ON : Boost low and high frequencies to produce a well-balanced sound at a low volume level. The LOUD indicator lights up. Audio X'over Adjust the cross over frequency. (☞ page 32) Volume Offset Adjust and store the auto-adjustment volume level for each source. (For discs, the adjustment is stored for each of the following categories: DVD/DVD-VR, VCD/CD, and DivX/ MPEG1/MPEG2/MP3/WMA/WAV/AAC.) The volume level will automatically increase or decrease when you change the source. ♦ -15 to +6; Initial 0 Preout Setup*1 ♦ Rear ♦ Subwoofer : Select this when rear speaker is connected to REAR/SW jacks through an amplifier. : Select this when subwoofer is connected to REAR/SW jacks. Subwoofer *2 ♦ ON ♦ OFF : Activates the subwoofer. : Cancels. Speaker Select Select the size of the connected speaker. ♦ Standard/Narrow/Middle/Wide *1 You can change the setting only when the unit is in standby. *2 Selectable only when is selected for . 38 DDX4028BT/DDX4058BT/DDX3028/DDX3058