Kenwood DDX8906S Quick Start Guide - Page 28
Connecting wires to terminals, Except DDX819WBTL
View all Kenwood DDX8906S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Connection/Installation ÑÑConnecting wires to terminals ●●Except DDX819WBTL Fuse (15A) White White/Black Gray Gray/Black Speaker impedance: 4-8 Ω To front left speaker To front right speaker Connect to the vehicle's parking brake detection switch Accessory 1 harness. Light Green PRK SW (Parking sensor wire) (2 m) For best safety, be sure to connect the parking sensor. Ignition key switch Red (Ignition wire) Yellow (Battery wire) Green Green/Black To rear left speaker Purple Purple/Black To rear right speaker If no connections are made, do not let the cable come out from the tab. Blue/White (Power control wire) P. CONT When using the optional power amplifier, connect to its power control terminal. (Max. 200mA, 12V) Car fuse box Black (Ground wire) ¤ (To car chassis) Battery Green/White CAM- Green/Red CAM+ To CMOS-3xx series (Optional Accessory) camera control terminal Pink (Speed Pulse Input) (2m) S SENS Connect to the vehicle's speed pulse harness. Do not cut the "S SENS" tag or failure may result. Purple/White (Reverse sensor wire) (2 m) REVERSE Connect to vehicle's reverse lamp harness when using the optional rear view camera. Light Blue/Yellow (Steering remote control wire) REMOTE CONT STEERING WHEEL REMOTE INPUT To steering remote To use the steering wheel remote control feature, you need an exclusive remote adapter (not supplied) matched to your car. Orange/White (Dimmer control wire) To car light control switch ILLUMI Blue (Antenna control wire) ANT CONT Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. (Max. 300mA, 12V) 28