Kenwood DNN9150BT Quick Start Guide - Page 20

Installation touching to cause a short circuit, then replace the old fuse with one with the same rating. ÑÑBefore Installation • Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not Before installation of this unit, please note the remove the caps on the ends of the unconnected following precautions. wires or the terminals. !!WARNINGS • If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. • Do not cut out the fuse from the ignition wire (red) and the battery wire (yellow). The power supply must be connected to the wires via the fuse. !!CAUTION • Install this unit in the console of your vehicle. Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot. • Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the ¤ wires or ground them to any metal part in the car. • When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the ¢ connector of the left speaker to a front output terminal, do not connect the ¤ connector to a rear output terminal. • After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly. • Mount the unit so that the mounting angle is 30° or less. ✎✎NOTES • Mounting and wiring this product requires skills and experience. For best safety, leave the mounting and wiring work to professionals. • Make sure to ground the unit to a negative 12V DC power supply. • Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. • This unit has the cooling fan (P.24) to decrease the internal temperature. Do not mount the unit in a place where the cooling fan of the unit is blocked. Blocking these openings will inhibit the cooling of the internal temperature and result in malfunction. • Do not press hard on the panel surface when installing the unit to the vehicle. Otherwise scars, damage, or failure may result. • Reception may drop if there are metal objects near the Bluetooth antenna and WI-FI receiver. • Do not use your own screws. Use only the screws Bluetooth antenna area provided. If you use the wrong screws, you could damage the unit. • If the power is not turned ON ("PROTECT" is displayed), the speaker wire may have a short- circuit or touched the chassis of the vehicle and the protection function may have been activated. Therefore, the speaker wire should be checked. HDMI/MHL • If your car's ignition does not have an ACC position, MIC AV-IN/OUT GPS M4 x 8mmMAX iPod/ AV-IN2 WiFi Recever SW FRONT REAR FUSE 10A connect the ignition wires to a power source that DNR8015BT/ can be turned on and off with the ignition key. If you DNR8015BTM connect the ignition wire to a power source with AV-OUT AUDIO a REMO TE POWER 5V=500mA WI-FI receiver constant voltage supply, such as with battery wires, R L the battery may be drained. • If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing HOME 6 • Install the WI-FI receiver besides the place enclosed by the metal. and opening. • If the fuse blows, first make sure the wires aren't 20 ñ English