Kenwood DNX7140 Installation Manual (pdf) - Page 2
Installation Procedure, Accessories
UPC - 019048182494
View all Kenwood DNX7140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Accessories Installation Procedure 1 0 1. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. 2. Make the proper input and output wire connections for each unit. ..........1 ..........1 3. Connect the speaker wires of the wiring harness. 4. Connect the wiring harness wires in the following 2 ! order: ground, battery, ignition. 5. Connect the wiring harness connector to the unit. 6. Install the unit in your car. DNX models only 7. Reconnect the - battery. ..........1 ..........1 8. Press the reset button. 3 @ 9. Perform the Initial Setup. (Refer to the Instruction Manual.) DNX models only ..........1 ..........1 4 # ..........1 ..........1 5 $ DNX models only ..........2 ..........1 6 ..........1 7 ⁄ ..........1 • About the model groups If different functions are 8 used in different model groups, the model groups are described as shown below. ..........6 Names of models included in each model group are as 9 follows: DNX models DNX7140, DNX7000EX DDX models ..........6 DDX714, DDX7034BT 2 | DNX7140/DNX7000EX/DDX714/DDX7034BT 2WARNING • If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. • Do not cut out the fuse from the ignition wire (red) and the battery wire (yellow). The power supply must be connected to the wires via the fuse. Acquiring GPS Signals The first time you turn on the DNX models, you must wait while the system acquires satellite signals for the first time. This process could take up to several minutes. Make sure your vehicle is outdoors in an open area away from tall buildings and trees for fastest acquisition. After the system acquires satellites for the first time, it will acquire satellites quickly each time thereafter. About the Front Panel When removing the product from the box or installing it, the front panel may be positioned at the angle shown in (Fig. 1). This is due to the characteristics of a mechanism the product is equipped with. If the program that is activated when the product is first powered on works properly, the front panel will automatically move into the position (initial setting angle) shown in (Fig. 2). (Fig. 1) (Fig. 2)