Kenwood DPX-MP2100 User Manual - Page 26
Troubleshooting Guide
View all Kenwood DPX-MP2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Troubleshooting Guide Some functions of this unit may be disabled by some settings made on this unit. ! Cannot switch to Aux source. ▲ AUX is not turned on. ☞ (page 20) ! • Cannot set up the subwoofer. • Cannot set up subwoofer phase. • No output from the subwoofer. • Cannot set up the low pass filter. ▲ • Preout is not set to subwoofer. ☞ (page 18) • (page 8) is not set to On. ! Cannot set up the subwoofer phase. ▲ Low pass filter is set to Through. ☞ (page 7) ! Cannot play audio files. ▲ (page 20) is set to "2". What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. General ? The Touch Sensor Tone doesn't sound. ✔ The preout jack is being used. ☞ The Touch Sensor Tone can't be output from the preout jack. Tuner source ? Radio reception is poor. ✔ The car antenna is not extended. ☞ Pull the antenna out all the way. ✔ The antenna control wire is not connected. ☞ Connect the wire correctly, referring to the section on (page 24). Disc source ? The specified disc does not play, but another one plays instead. ✔ The specified CD is quite dirty. ☞ Clean the CD. ✔ The disc is loaded in a different slot from that specified. ☞ Eject the disc magazine and check the number for the specified disc. ✔ The disc is severely scratched. ☞ Try another disc instead. Audio file source ? The sound skips when an Audio file is being played. ✔ The media is scratched or dirty. ☞ Clean the media, referring to the CD cleaning of the section on (page 4). ✔ The recording condition is bad. ☞ Record the media again or use another media. 26 | English