Kenwood DPX-MP3110 User Manual 1 - Page 8

General Operation Audio Setup You can set Sound system, such as follows; Adjustment Item Display Front High Pass Filter "HPF" Rear High Pass Filter "HPR" Low Pass Filter Subwoofer Phase Volume offset Loudness Dual Zone System "LPF" "PHAS" "V-Off" "LOUD" "2ZON" Range Through/40/60/80/100/120/ 150/180/220 Hz Through/40/60/80/100/120/ 150/180/220 Hz 50/60/80/100/120/Through Hz Reverse (180°)/ Normal (0°) -8 - ±0 (AUX: -8- +8) Off/On Off/On ⁄ • Volume offset: Sets each source's volume as a difference from the basic volume. • Loudness: Compensates for low and high tones during low volume. (Only the low tone is compensated for when the tuner is selected as a source.) • Dual Zone System Main source and sub source (Auxiliary input) output Front channel and Rear channel separately. - Set up the channel of sub source by "Zone2" of (page 14). - Select Main source by [SRC] button. - Adjust the volume of Front channel by Control knob. - Adjust the volume of Rear channel by (page 7). - The Audio Control has no effect on sub source. 1 Select the source to adjust Press the [SRC] button. 2 Enter Audio Setup mode Press the Control knob for at least 1 second. 3 Select the Audio Setup item to adjust Press the Control knob. 4 Adjust the Audio setup item Turn the Control knob. 5 Exit Audio Setup mode Press the Control knob for at least 1 second. Speaker Setting Fine-tuning so that the System Q value is optimal when setting the speaker type as follows; Speaker type OFF For 5 & 4 in. speaker For 6 & 6x9 in. speaker For the OEM speaker Display "SP Off" "SP 5/4" "SP 6*9/6" "SP OEM" 1 Enter Standby Press the [SRC] button. Select the "STANDBY" display. 2 Enter Speaker Setting mode Press the Control knob. "SP SEL" is displayed. 3 Select the Speaker type Turn the Control knob. 4 Exit Speaker Setting mode Press the Control knob. Sound Enhancer Select You can play back adding gorgeous heavy bass to the sound. 1 Enter the Sound Effect mode Press the [SE] button. "SE SEL" is displayed. 2 Select the Sound effect item Turn the Control knob. Sound effect Returns to the normal sound without Sound effect. Moves the sound image up a notch and adjusts bass Moves the sound image up two notches and adjusts bass. Display "SE Off" "SE Low" "SE High" Changes to the value set in (page 9). "SE User" When the Sound effect is ON, the "SE" indicator is ON. 3 Exit the Sound Effect mode Press the [SE] button. 8 | DPX-MP5110U/DPX-MP4110/DPX-MP3110