Kenwood DPX502 Instruction Manual - Page 33
Connecting Wires to Terminals - harness
View all Kenwood DPX502 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Connecting Wires to Terminals ⁄ To connect these leads, refer to the relevant instruction manuals. To Kenwood disc changer/ External optional accessory Fuse (10A) FM/AM antenna input Front left output (White) Front right output (Red) Wiring harness (Accessory1) Rear left output (White)/ Sub Woofer left output (White) Rear right output (Red)/ Sub Woofer right output (Red) If no connections are made, do not let the wire come out from the tab. Power control wire (Blue/White) Motor antenna control wire (Blue) TEL mute wire (Brown) P.CONT ANT. CONT MUTE Dimmer control wire (Orange / White) ILLUMI When using the optional power amplifier, connect to its power control terminal. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. Connect to the terminal that is grounded when either the telephone rings or during conversation. ⁄ To connect the Kenwood navigation system, consult your navigation manual. To car light control switch FRONT L FRONT R REAR L REAR R White White/Black Gray Gray/Black Green Green/Black Purple Purple/Black To front left speaker To front right speaker To rear left speaker To rear right speaker Ignition wire (Red) Car fuse box ACC Battery wire (Yellow) Ground wire (Black) - (To car chassis) Ignition key switch Car fuse box (Main fuse) - Battery + English | 33