Kenwood KDC-BT360U Quick Start Guide 1 - Page 9
Part list supplied
View all Kenwood KDC-BT360U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installing the unit (without mounting sleeve) 1 Remove the mounting sleeve and trim plate from the unit. 2 Align the holes in the unit (on both sides) with the vehicle mounting bracket and secure the unit with screws (supplied/ commercially available). Use only the specified screws. Using wrong screws might damage the unit. Wiring connection Fuse (10 A) Antenna terminal If no connections are made, do not let the wire come out from the tab. Removing the unit Part list (supplied) (A) Faceplate (×1) (B) Trimplate (×1) (C) Mounting sleeve (×1) (D) Wiring harness (×1) (E) Extraction key (×2) (F) Screw (supplied for / / / / ) M5 × 7 mm (×4) M5 × 6 mm (×4) M4 × 8 mm (×1) Car fuse box Ignition switch Car fuse box Battery a Brown: To connect the KENWOOD navigation system, refer your navigation manual b Blue/white: To the power control terminal when using the optional power amplifier or to the antenna control terminal in the vehicle c Light blue/yellow: To the steering wheel remote control adapter or to KENWOOD Marine Remote Control unit (optional accessory) for d Red: Ignition 12 V e Yellow: Battery 12 V f Black: Ground g White ª, White/black ·: Front speaker (left) h Gray ª, Gray/black ·: Front speaker (right) i Green ª, Green/black ·: Rear speaker (left) j Purple ª, Purple/black ·: Rear speaker (right) 3