Kenwood KDC-BT755HD Quick Start Guide - Page 9
Installing the Unit, Installing without using the mounting sleeve (Japanese car), Removing the Unit - installation
View all Kenwood KDC-BT755HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installing the Unit 1 3 2 1 B A 2 Make sure the direction of the trim plate. The shape of the hooks on the top side is as illustrated. 4 5 A Connect the wiring harness to C the unit. Other wiring connection have been completed earlier. (page 8) 3 B 1 C D 2 Dashboard of your car Bend the appropriate tabs to hold the mounting sleeve firmly in place. Installing without using the mounting sleeve (Japanese car) 1 Remove the mounting sleeve C and trim plate B from the unit. 2 Align the holes in the unit (on both sides) with the vehicle mounting bracket and secure the unit with the supplied screws. B F ø5mm 8 mm MAX. 8mm MAX. G ø5mm Removing the Unit 1 Detach the faceplate A. 2 Engage the catch pin on the extraction key E into the holes on both sides of the trim plate B, then pull it out. 3 Insert the extraction key E deeply into the slots on each side, then follow the arrows instructions as shown on the right. E B 12 A E C 3 Installing the Microphone Unit 1 Check the installation position of the microphone H. 2 Remove oil and other dirt from the H installation surface. 3 Install the microphone. 4 Wire the microphone cable up to the unit with it secured at several positions using tape or other desired method. Fix a cable with a commercial item of tape. Peel the release coated paper of double-face adhesive tape to fix on the place shown above. Adjust the direction of the microphone to the driver. English | 9