Kenwood KDC-BT852HD Quick Start Guide - Page 10
Before installation, Installation - wiring
View all Kenwood KDC-BT852HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Installation Before installation 1 .....1 2 .....2 3 .....4 4 .....4 5 (KDC-X896, KDC-BT852HD only) .....1 (3m) 10 | Quick Start Guide 2 WARNING • The unit can only be installed in a car with a 12V DC power supply, negative ground. • If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. ¤ CAUTION • Install this unit in the console of your vehicle. • Do not touch the metal parts of this unit during and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot. • Mounting and wiring this product requires skills and experience. For safety's sake, leave the mounting and wiring work to professionals. • If you experience any problem during installation, consult your Kenwood dealer. • Disconnect the battery's negative terminal before installing the unit. • Insulate unconnected wires with vinyl tape or other similar materials. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires and terminals. • Be sure to ground this unit to the car's chassis again after mounting. • If the fuse blows, first make sure the wires are not touching other parts to cause a short circuit, and then replace the old fuse with one with a new the same rating. • When connecting only two speakers, connect the connectors either to both of the front output terminals or to both of the rear output terminals (do not mix front and rear terminals). For example, if you connect the + connector of the left speaker to a front output terminal, do