Kenwood KDC-BT945U Instruction Manual - Page 71
Installation/Removing the Unit, non-Japanese cars, Removing the hard rubber frame, Removing the Unit
View all Kenwood KDC-BT945U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Installation/Removing the Unit non-Japanese cars Removing the hard rubber frame 1 Engage the catch pins on the removal tool and remove the two locks on the upper level. Upper the frame and pull it forward as shown in the figure. Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. ⁄ • Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip). Japanese cars 1 Refer to the section and then remove the hard rubber frame. 2 Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and secure the unit with the accessory screws. T N T/N NT T: Toyota cars N: Nissan cars Lock Catch Accessory2 Removal tool 2 When the upper level is removed, remove the lower two locations. ⁄ • The frame can be removed from the bottom side in the same manner. Removing the Unit 1 Refer to the section and then remove the hard rubber frame. 2 Detach the faceplate. 3 Insert the two removal tools deeply into the slots on each side, as shown. 4 Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. Accessory2 3 ø5mm 8 mm MAX. 4 ø5mm Accessory3...for Nissan car Accessory4...for Toyota car 8mm MAX. ¤ CAUTION Install this unit in the console of your vehicle. Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot. ¤ • Be careful to avoid injury from the catch pins on the removal tool. 5 Pull the unit all the way out with your hands, being careful not to drop it. English | 71