Kenwood KDC-M9021 User Manual 1 - Page 11

Adjustment Item Display Range Bass Center Frequency "Bass FRQ" Bass level "Bass" Bass Q Factor "Bass Q" Bass Extend "Bass EXT" Middle Center Frequency "MID FRQ" Middle level "MID" 60/70/80/100 or 150 Hz -8 - +8 1.00/1.25/1.50/2.00 ON/OFF 0.5/1.0/1.5/2.0 kHz -8 - +8 Middle Q Factor "Middle Q" 1.0/2.0 Treble Center Frequency"TRE FRQ" 10.0/12.5/15.0/17.5 kHz Treble level "TRE" -8 - +8 Balance "Balance" Left 15 - Right 15 Fader "Fader" Rear 15 - Front 15 Non-Fading level* "NF Level" -15 - +15 Front High Pass Filter* "HPF Front" Through/40/60/80/100/ 120/150/180/220 Hz Rear High Pass Filter* "HPF Rear" Through/40/60/80/100/ 120/150/180/220 Hz Non-Fading Low Pass Filter* "LPF NF" 50/80/120/Through Hz Non-Fading Phase* "NF Phase" Normal (0°)/Reverse (180°) Volume offset "Volume Offset" -8 - ±0 Loudness "LOUD" ON/OFF • According to the Bass Q Factor setting value, the frequencies that can be set in Bass Center Frequency change as shown below. Bass Q Factor Bass Center Frequency 1.00/1.25/1.50 60/70/80/100 2.00 60/70/80/150 • When the bass extend is set to ON, low frequency response is extended by 20%. • Volume offset: Each source's volume can be set as a difference from the basic volume. • Loudness: Compensating for low and high tones during low volume. (KDC-PSW9521) The graphic is displayed when Loudness is ON, and is switched OFF when Loudness is OFF. • * :Function of the KDC-PSW9521/ KDC-M9021SE/ KDC-M9021 5 Exit Audio Control mode Press the [AUD] button. Function of the KDC-PSW9521/KDC-M9021SE/KDC-M9021 Non-fading Output Turning the Non-fading output ON or OFF. Press the [NF] button for at least 1 second. Each time the button is pressed Non-fading output switches ON or OFF. When it's ON, "NF ON" is displayed. Faceplate Angle Adjustment Press the [ANG] button for at least 1 second. Do not apply excessive force to the faceplate. It can cause damage. - 11 -