Kenwood KDC-MP335 Instruction Manual - Page 20

Menu system In Standby mode Touch Sensor Tone Setting the operation check sound (beep sound) ON/OFF. Display "BEEP ON" "BEEP OFF" Setting Beep is heard. Beep canceled. In Standby mode Manual Clock Adjustment 1 Select Clock Adjustment mode Push the Control knob towards [FM] or [AM]. Select the "CLK ADJ" display. 2 Enter Clock Adjust mode Press the Control knob for at least 1 second. The clock display blinks. 3 Adjust the hours Push the Control knob towards [FM] or [AM]. Adjust the minutes Push the Control knob towards [4] or [¢]. 4 Exit Clock adjustment mode Press the [MENU] button. In Standby mode DSI (Disabled System Indicator) A red indicator will blink on the unit after the faceplate is removed, warning potential thieves. Display "DSI ON" "DSI OFF" Setting LED flashes. LED OFF. Display Illumination Control This function turns off the display when you perform no operation for 5 seconds. This function is effective when you are driving at night. Display "DISP ON" "DISP OFF" Setting Keeps the display on. Turns off the display when you perform no operation for 5 seconds. ⁄ • Set the Display Illumination Control when the (page 23) is set to OFF. • When the display is off, pressing any key will turn on the display. • When the display is off, you cannot perform any operation except for the following: • Volume • Attenuator • Selecting the source • Turning off the power • During function control, such as the Menu System, the display stays on. Dimmer You can lower the brightness of the display by using the dimmer function. Display "DIM ON" "DIM OFF" Setting The display dims. The display doesn't dim. Function of KDC-MP335 In Standby mode Switching preout Alternating the preout between the rear and subwoofer. (With the subwoofer the sound outputs without being effected by fader control.) Display "SWPRE R" "SWPRE SW" Setting Rear preout. Subwoofer preout. 20 | English