Kenwood KDC MP338 Instruction Manual - Page 19

Connecting Wires to Terminals REMO.CONT Steering remote control (Light Blue/Yellow) (KDC-X492/MP438U/MP408U only) To use the steering wheel remote control feature, you need to an exclusive remote adapter (not supplied) matches your car is required. When this terminal is not in use, leave its cap on. Front preout (KDC-MP338 only) KDC-X492/MP438U Rear preoput L R Front preoput SubWwoofer prepout Fuse (10A) FRONT FM/AM antenna input (KDC-X492/MP438U/MP408U) FM/AM antenna input (KDC-MP338) To Kenwood disc changer/ External optional accessory KDC-MP408U L R Rear/pSruebowuto/oSfuebr Wproeopfuetr preout KDC-MP338 L RReeaarr/pSreuobuwto/SoufebrWporeopfeurt preout R Wiring harness (Accessory1) If no connections are made, do not let the wire come out from the tab. Power control/Motor antenna control wire (Blue/White) P.CONT TEL mute wire (Brown) MUTE Motor antenna control wire (Blue) ANT. CONT Dimmer control wire (Orange / White) (KDC-X492/MP438U/MP408U only) ILLUMI Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle. Connect to the terminal that is grounded when either the telephone rings or during conversation. ⁄ To connect the Kenwood navigation system, consult your navigation manual. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. To car light control switch White/Black White To front left speaker Gray/Black Gray Green/Black Green To front right speaker To rear left speaker Purple/Black Purple Ignition wire (Red) To rear right speaker Ignition key switch Car fuse box ACC Battery wire (Yellow) Ground wire (Black) - (To car chassis) + Car fuse box (Main fuse) - Battery English | 19