Kenwood KDCMPV7019 Instruction Manual - Page 11
Enter Standby, Enter Speaker Setting mode, Select the Speaker type, Speaker type, Display
UPC - 019048136985
View all Kenwood KDCMPV7019 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Adjustment Item Display Range Bass Center Frequency (KDC-X459 only) Bass level Bass Q Factor (KDC-X459 only) Bass Extend (KDC-X459 only) Middle Center Frequency (KDC-X459 only) Middle level Middle Q Factor (KDC-X459 only) Treble Center Frequency (KDC-X459 only) Treble level Balance Fader Volume offset "Bas F" "Bas"/"BAS" "BasQ" "BasEX" "MidF" "Mid"/"MID" "MidQ" "TreF" "Tre"/"TRE" "Bal"/"BAL" "Fad"/"FAD" "V-OFF" 60/70/80/100 or 150 Hz -8 - +8 1.00/1.25/1.50/2.00 ON/OFF 0.5/1.0/1.5/2.0 kHz -8 - +8 1.0/2.0 10.0/12.5/15.0/17.5 kHz -8 - +8 Left 15 - Right 15 Rear 15 - Front 15 -8 - ±0 • According to the Bass Q Factor setting value, the frequencies that can be set in Bass Center Frequency change as shown below. Bass Q Factor Bass Center Frequency 1.00/1.25/1.50 60/70/80/100 2.00 60/70/80/150 • When the Bass Extend is set to ON, low frequency response is extended by 20%. • Volume offset: Each source's volume can be set as a difference from the basic volume. 5 Exit Audio Control mode Press the [AUD] button. Speaker Setting Fine-tuning so that the System Q value is optimal when setting the speaker type. 1 Enter Standby Press the [SRC] button. Select the "ALL OFF" display. 2 Enter Speaker Setting mode Press the [Q] button. 3 Select the Speaker type Press the [4] or [¢] button. Each time the button is pressed the setting switches as shown below. Speaker type Display OFF For 5 & 4 in. speaker For 6 & 6x9 in. speaker For the OEM speaker "SP OFF" "SP 5/4" "SP 6*9/6" "SP OEM" 4 Exit Speaker Setting mode Press the [Q] button. - 11 -