Kenwood KMR-350U Instruction Manual - Page 15
Continued
View all Kenwood KMR-350U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
PRESET EO BASS BOOST LOUDNESS BALANCE FADER SUBWOOFER SETI SUB-W SET 60/ 80/ 100 *I 200: Selects the center frequency. BASS LEVEL -8- +8 (Preset: 0): Adjusts the level. BASS 0 FACTOR 1.00 *I 1.25/ 1.50/ 2.00: Adjusts the quality factor. BASS EXTEND ON: Turns on the extended bass.; OFF*: Cancels. MID CTR FRO 0.5K/ 1.0K *I 1.5K/ 2.5K: Selects the center frequency. MID LEVEL -8- +8 (Preset: 0): Adjusts the level. MID 0 FACTOR 0.75/ 1.00 *I 1.25: Adjusts the quality factor. TRE CTR FRO lO.OK/ 12.5K */ 15.0K/ 17.5K: Selects the centerfrequency. TRE LEVEL -8- +8 (Preset: 0): Adjusts the level. NATURAL*I USER/ ROCK/ POPS/ EASYI TOP40/ JAZZ/ POWERFUL: Selects apreset sound mode suitable to the music genre. (Selects [USER] to use the customized bass, middle, and treble settings.) B. BOOST LV1/ B. BOOST LV2/ B. BOOST LV3: Selects your preferred bass boost level.; OFF*: Cancels. LOUDNESS LVl *I LOUD LV1 *I LOUDNESS LV2/ LOUD LV2: Selects your preferred low and high frequencies boost to produce awell-balanced sound at alow volume level.; OFF: Cancels. L15 - R15 (Preset: 0): Adjusts the left and right speaker output balance. R15 - F15 (Preset: 0): Adjusts the rear and front speaker output balance. ON*: Turns on the subwoofer output.; OFF: Cancels. REVERSE/ REV (180°)/ NORMAL/ NORM (0°) *:Selects the phase angle of the subwoofer output to be in line with the speaker output for optimum performance. (Selectable only if asetting other than [THROUGH] is selected for [LPF SUBWOOFER] I [LPF SUB-W].) ON*: Creates realistic sound by interpolating the high-frequency components that are lost in MP3/ WMA audio compression. ; OFF: Cancels. (Selectable only when playback an MP3/WMA disc or aUSB device, except iPod.) VOLUME OFFSETI -8- +8 (for AUX); -8- 0 (for other sources): Presets the volume adjustment level of each VOL OFFSET source. The volume level will automatically increase or decrease when you change the source. (Before making an adjustment, select the source you want to adjust.) • [SUB-W LEVEL/ SUB-W SET/ LPF SUB-WI SUB-W PHASE] is selectable only if [SWITCH PRE] is set to [SUB-W]. (page 8) • [SUB-W LEVEL/ LPF SUB-WI SUB-W PHASE] is selectable only if [SUB-W SET] is set to [ON]. Continued... 15