Kenwood KNA G510 Instruction Manual - Page 3
Steps to install the KNA-G510 - navigation system
UPC - 019048166852
View all Kenwood KNA G510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
English Optional accessory: XM Smart Antenna or FM traffic receiver SD card GPS antenna Installing the GPS antenna Better (trunk of vehicle) Best (roof of vehicle) Good (inside car on dashboard) Steps to install the KNA-G510 1. Remove the key from the vehicle's ignition and disconnect the negative battery cable. 2. Install the GPS antenna. Refer to the tips on the previous page. 3. Connect the wiring harness to your vehicle in the following order: ground, battery, ignition. 4. Connect the wiring harness to the main unit. 5. Install the main unit. Refer to the tips on the previous page. 6. Reconnect the negative battery cable. Black To vehicle chassis 2 A Red To ignition (12 V) 2 A Yellow To battery (12 V) CAUTION If your vehicle's ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the vehicle's battery may die. Light green To parking brake detection switch To display unit (NAV I/F terminal) Ignition key switch Car fuse box Car fuse box (main fuse) WARNING Do not connect the yellow wire lead directly to the vehicle battery. Connecting directly to the battery may cause the wire insulation to fail and may pose a risk of short circuit and electric shock. WARNING Be sure to connect the parking brake wire to ensure safe navigation.