Kenwood KRC-21R User Manual - Page 21
Other features
View all Kenwood KRC-21R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Other features (See page 7) Audio Control Setting Adjust various parameters of sound quality. 1 Press the AUD button to enter the control mode. Each time the AUD button is pressed, the adjustment mode display changes as follows: 7 Bass 7 Treble 7 Balance 7 Fader 7 Volume If you do not move to step 2 in 5 seconds, the unit will switch back to the volume adjustment mode (i.e., the normal mode). NOTE Source tone memory Each source (tape, FM, AM, and disc changer) has its own memory in which to store the bass and treble tone settings. The settings made for a particular source are then recalled automatically whenever you use that source (e.g., FM mode uses the tone settings made for FM, AM for AM, etc.). 2 Press the d/u buttons to adjust the mode shown in the display. Use the following table as a guide for adjusting the settings in each mode. Adjustment mode (Display) Operation of Audio control button d button u button Bass ("BAS") Bass decreased. Bass increased. Treble ("TRE") Treble decreased. Treble increased. Balance ("BAL") Left channel empha- Right channel empha- sized. sized. Fader ("FAD") Rear channel increased. Front channel increased. Clock Display Display the time. Adjusting Time When the RDS station tuned into is transmitting a time signal, have the unit's built-in time adjust automatically to the correct local time. Adjusting the Time: Tune into an RDS station for 3 or 4 minutes. The time adjusts automatically to the correct local time. NOTE • The displayed time cannot be set manually, but only through RDS station time signals. • The time is not adjusted when the RDS station you are tuned to is not transmitting a time signal. Choose another RDS station in such a case. Function of the KRC-259R,159RA/RG,21R TEL Mute Function 1 Shut down the audio system temporarily whenever an incoming call is received. NOTE The function will not work if a cable is not connected to the car phone. When the telephone rings: When a call is received, "CALL" is displayed and all the unit functions are temporarily interrupted. Restoring Original Unit Source During Phone Call: Press the SRC button. "CALL" disappears from the display, and the volume of the original source is restored gradually. Turning TEL Mute Function Off After Phone Call: Hang the phone up. "CALL" disappears from the display. The original source (i.e., the one used before the phone call) is returned to automatically, and the volume restored gradually. Switching to Time Display: Press the CLK button repeatedly until the clock is displayed. - 21 -