Kenwood KRC-535 Instruction Manual - Page 30
The messages shown below display your systems, condition. - guide
UPC - 019048136459
View all Kenwood KRC-535 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Troubleshooting Guide English The messages shown below display your systems condition. Eject: No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.E01 ➪ Load the disc magazine properly. No CD in the unit. ➪ Insert the CD. No Disc: No disc has been loaded in the disc magazine.E02 ➪ Load a disc into the disc magazine. TOC Error: No disc has been loaded in the disc magazine.E04 ➪ Load a disc into the disc magazine. The CD is quite dirty. The CD is upside-down. The CD is scratched a lot. ➪ Clean the CD and load it correctly. Blank DISC: Nothing has been recorded on the MD.E10 No Tr DISC: No tracks are recorded on the MD, although it has a title.E11 NO PANEL: The faceplate of the slave unit being connected to this unit has been removed.E30 ➪ Replace it. E-77: The unit is malfunctioning for some reason.E77 ➪ Press the reset button on the unit. If the "E-77" code does not disappear, consult your nearest service center. turning on the air conditioner. As the temperature falls below 60°C (140°F), the disc will start playing again. NO NAME: • Attempted to display DNPS during the CD play having no disc names preset.E51 • Attempted to display SNPS during the receiving session of the station having no station name preset.E50 NO TITLE: Attempted to display the disc title or track title while the MD having no MD title is being played.E53 NO TEXT: Attempted to display the disc text or track text while the CD having no CD text is being played.E54 Load: Discs are being exchanged in the Disc changer.E57 NO ACCESS: After setting it in the Disc Changer, DNPP was done without having it been played at least 1 time.E58 IN (Blink): The tape player section is not operating properly.E60 ➪ Reinsert the Tape. If the tape cannot be ejected or the display continues to flash even when the tape has been properly reinserted, please switch off the power and consult your nearest service center. NOT.AVAILABLE: Adjust the panel angle during tape play. E62 Mecha Error: Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.E99 ➪ Check the disc magazine. And then press the reset button on the unit. If the "Mecha Error" code does not disappear, consult your nearest service center. Hold Error: The protective circuit in the unit activates when the temperature inside the automatic disc changer exceeds 60°C (140°F), stopping all operation.E0d ➪ Cool down the unit by opening the windows or - 30 -