Kenwood KVT-627DVD User Manual 1 - Page 4

Connection When handling an optical cable for wiring, use care not to exceed the minimum cable bend radius of 30 mm. If you exceed the minimum bend limit, optical fibers within the optical cable may be damaged. 30R Optical output (KVT-827DVD/727DVD only) Monitor unit An Optical cable (Accessory 3) is fixed with a chassis using harness band (Accessory $). (KVT-827DVD/727DVD only) For the sake of safety, be sure to connect the parking sensor. Connect to the vehicle's parking brake detection switch harness using the supplied relay connector. (Black) Accessory 4 Parking sensor wire (Green) PRK SW To vehicle's reverse lamp harness To Steering remote Reverse sensor wire (Pink) REVERSE Steering remote control input (Light Blue/Yellow) REMO.CONT E + Dimmer control wire (Orang/White) D ILLUMI Ignition wire (Red) A ACC (5A) B Battery wire (Yellow) BATT C Ground wire (Black) - (To car chassis) Receiver unit (front side) Battery Antenna Cord Accessory ! FM/AM antenna input FM /AM ANTENNA AV INPUT 2 VIDEO L AV INPUT 1 VIDEO L AV OUTPUT R L R-CAM V-IN CENTER SUB R R VIDEO [MONO] PRE OUTPUT REAR FRONT L L R R POWER Accessory 5 To Subwoofer system Accessory # (KVT-827DVD/727DVD only) If no connections are made, do not let the cable come out from the tab. Accessory 1 Connect to the terminal that is grounded when either the telephone rings or during conversation. To connect the Kenwood navigation system, consult your navigation manual. Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle. To "EXT.AMP.CONT." terminal of the amplifier having the external amp control function. 4 | English Mute wire (Brown) MUTE Power control/ Motor antenna control cable (Blue/White) P. CONT ANT CONT External amplifier control wire (Pink/Black) EXT.CONT (10A)