Kenwood TH-G71A User Manual - Page 19
Selecting Offset Direction, Selecting Offset Frequency
View all Kenwood TH-G71A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
■ Selecting Offset Direction Select whether the transmit frequency will be higher (+) or lower (-) than the receive frequency. 1 Select the desired band. 2 Press [F], [REV]. • Each time you repeat this key operation, the offset direction changes as shown below. TH-G71A/E Simplex + - (VHF) TH-G71A (UHF) TH-G71E (UHF) Simplex + - : Programs -7.6 MHz offset. If the offset transmit frequency falls outside the allowable transmit frequency range, transmitting is inhibited until the transmit frequency is brought within the band limits by one of the following methods: • Move the receive frequency further inside the band. • Change the offset direction. Note: While using an odd-split memory channel or transmitting, you cannot change the offset direction. ■ Selecting Offset Frequency Select how much the transmit frequency will be offset from the receive frequency. The default offset 1 frequency on the VHF band is 600 kHz no matter which market version; the default on the UHF band is 2 5 MHz (TH-G71A) or 1.6 MHz (TH-G71E). 1 Select the desired band. 3 2 Press [F], [BAND] to enter Menu mode. 4 3 Select Menu No. 8 (OFFSET). 5 6 7 4 Press [BAND], then select the appropriate offset frequency. 8 • The selectable range is from 00.000 MHz to 29.950 MHz in steps of 50 kHz. 9 2 1 10 11 5 Press [BAND] again to complete the setting. 12 6 Press any key other than [BAND], [LAMP], and [MONI] to exit Menu mode. 13 TH-G71E only: If you have selected " " for the offset direction, you cannot change the default (-7.6 MHz). 14 Note: After changing the offset frequency, the new offset frequency will also be used by Automatic Repeater Offset. 15 13