Kenwood TK-2200V2P Instruction Manual - Page 26
Temporary Delete
View all Kenwood TK-2200V2P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
To start scanning, press the Side 2 key. • The LED indicator flashes green and scanning starts from the current channel and ascends through the channel numbers. • When a signal is detected on a channel and the QT/DQT matches, scan pauses at that channel and the LED indicator lights green. • When the signal is no longer present, scanning continues after 3 seconds (default). To end Scan, press the Side 2 key again. ■ Temporary Delete You can temporarily remove specific channels from the scanning sequence during Scan. When Scan pauses at a channel, you can remove that channel from the scanning sequence by pressing and holding the Side 2 key for 3 seconds. • You cannot remove a channel if there will be less than 2 channels available for scanning remaining. • To add the removed channels back into the Scan list, simply exit Scan mode or switch the transceiver power OFF and then ON again. TK-3200L (K3) Model: The default function of the Side 2 key is Calling Alert. Calling alert tones are used to identify yourself to your party members and inform them that you are about to make a call. To make a call using the calling alert tone, press and hold the PTT switch, then press the key programmed as Side 2. • The calling alert tone will transmit for the duration you press the Side 2 key. Note: The Side1 and Side2 keys can be reprogrammed {page 31}. 18